JVC GR-AXM1U manual VCR Recording deck, PLAY/PAUSE Edit, Power switch

NOTES:

Press PLAY on the camcorder and engage the VCR’s Record mode.

STOP EDITING TEMPORARILY

Engage the VCR’s Record-Pause mode and press PAUSE on the camcorder.

EDIT MORE SEGMENTS

Repeat steps 4 through 6 for additional editing, then stop the VCR and camcorder when finished.

5

6

7

START EDITING

FIND EDIT-IN POINT

Engage the VCR’s AUX and Record-Pause modes.

3

4 Engage the camcorder’s Play mode to find a spot just before the edit-in point. Once it’s reached, press PAUSE on the camcorder.

Tape Dubbing

CONNECT EQUIPMENT

1 Following the illustration on the left, connect the camcorder and the VCR. If you have a Remote PAUSE terminal, use the editing cable to connect it to the camcorder and the VCR. (See “NOTES” below for details.)

PREPARE FOR DUBBING

2 Set the camcorder’s power switch to PLAY, turn on the VCR’s power, and insert the appropriate cassettes in the camcorder and the VCR.

SELECT VCR MODE

EDITING 35

PLAY/PAUSE

EDIT

To EDIT

Editing cable (optional 3.5 ø mini-plug cable)

Power switch

To AUDIO out

To VIDEO out

Audio and Video cable (optional)

To Remote

PAUSE

To AUDIO IN To VIDEO IN

VCR (Recording deck)

● When using a Remote PAUSE terminal, pressing EDIT on the camcorder in step 5 automatically engages the VCR’s Record mode.

●When using a Remote PAUSE terminal, you can access a function called Master Edit Control System. Before beginning, reset the camcorder’s counter to “M0:00:00” at an edit-out point. When the tape reaches this point (remember there’s a small margin of error) during editing, the camcorder and VCR pause automatically. However, some VCRs are not compat- ible with the Master Edit Control System.