JVC GR-D200 manual Auto Focus, Manual Focus, En#

Auto Focus

The camcorder’s Full Range AF system offers continuous shooting ability from close-up (as close as approx. 5 cm (2”) to the subject) to infinity.

Focus detection zone

However, correct focus may not be obtainable in the situations listed below (in these cases perform “Manual Focus”):

●When two subjects overlap in the same scene.

●When illumination is low.*

●When the subject has no contrast (difference in brightness and darkness), such as a flat, one-color wall, or a clear, blue sky.*

●When a dark object is barely visible in the LCD monitor or the viewfinder.*

●When the scene contains minute patterns or identical patterns that are regularly repeated.

●When the scene is affected by sunbeams or light reflecting off the surface of a body of water.

●When shooting a scene with a high-contrast background.

*The following low-contrast warnings appear blinking: , , and .

NOTES:

●If the lens is smeared or blurred, accurate focusing is not possible. Keep the lens clean. ( pg. 77) When condensation occurs, wipe with a soft cloth or wait for it to dry naturally.

●When shooting a subject close to the lens, zoom out first. ( pg. 18) If zoomed-in in the auto focus mode, the camcorder may automatically zoom out depending on the distance between the camcorder and the subject. This will not occur when “TELE MACRO” is set to “ON”. ( pg. 36)

EN￿"#

Manual Focus

NOTE:

If you are using the viewfinder, you should already have performed “Viewfinder Adjustment”

( pg. 12).

1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.

2Press FOCUS. The manual focus indicator appears.

3To focus on a further subject, press +. The “ ” indicator appears and blinks.

While focusing on a further subject

Manual focus
indicator
To focus on a nearer subject, press –. The “ ”
indicator appears and blinks.
While focusing on a
nearer subject	FEATURES
Manual focus
indicator	ADVANCED
4 Press SELECT/SET. Focus adjustment is complete.
To reset to Auto Focus...
Press FOCUS twice or set the Power Switch to “A”.

NOTES:

●Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you focus in on a subject in the wide-angle position, sharply focused images cannot be obtained when zoomed up because the depth-of-field is reduced at longer focal lengths.

●When the focus level cannot be adjusted any further or closer, “ ” or “ ” will blink.