JVC GR-D200 manual Other problems, Angle of the LCD monitor, Camcorder When the LCD monitor’s

% ￿EN			TROUBLESHOOTING (cont.)
Other problems
	SYMPTOM		POSSIBLE CAUSES		CORRECTIVE ACTION
24.	The POWER/CHARGE lamp	24.	•The temperature of the	24.	•To protect the battery, it is
	on the camcorder does not		battery is extremely high/		recommended to charge it in
	light when the charging is		low.		places with a temperature of
	attempted.		•Charging is difficult in places		10°C to 35°C (50°F to 95°F).
			subject to extremely high/		( pg. 74)
			low temperatures.
25.	“SET DATE/TIME!” appears.	25.	•The built-in clock’s	25.	•Connect the camcorder to an
			rechargeable lithium battery		AC outlet using the AC
			is discharged.		Adapter for over 24 hours to
			•The previously set date/time		charge the clock’s lithium
			is erased.		battery. ( pg. 14)
26.	There is no picture.	26.	•The camcorder is not getting	26.	•Turn the camcorder’s power
			power, or some other		off and on again. ( pg. 13)
			malfunction exists.
27.	Some functions are not	27.	•The Power Switch is set to	27.	•Set the Power Switch to “M”.
	available using the MENU		“A”.		( pg. 13)
	Button.
28.	Files stored in the memory	28.	•Files stored in the memory	28.	•Remove protection from the
	card cannot be deleted.		card are protected.		files stored in the memory
					card and delete them.
					( pg. 27 –28)
29.	When the image is printed	29.	•This is not a malfunction.	29.	•By recording with “DIS”
	from the printer, a black bar				activated ( pg. 31, 36) this
	appears at the bottom of the				can be avoided.
	screen.
30.	When the camcorder is	30.	•The DV cable was plugged/	30.	•Turn the camcorder’s power
	connected via the DV		unplugged with power		off and on again, then
	connector, the camcorder does		turned on.		operate it.
	not operate.
31.	The rear of the LCD monitor is	31.	•The light used to illuminate	31.	•Close the LCD monitor to
	hot.		the LCD monitor causes it to		turn it off or set the Power
			become hot.		Switch to “OFF”, and let the
					unit cool down.
32.	Images on the LCD monitor	32.	•In places subject to low	32.	•Adjust the brightness and
	appear dark or whitish.		temperature, images become		angle of the LCD monitor.
			dark due to the		( pg. 12, 13)
			characteristics of the LCD
			monitor. When this happens,
			the displayed colors differ
			from those that are actually
			recorded. This is not a defect
			of the camcorder.
			•When the LCD monitor’s
			fluorescent light reaches the
			end of its service life, images
			on the LCD monitor become
			dark. Consult your nearest
			JVC dealer.