$EN | USING THE REMOTE CONTROL UNIT (cont.) |
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
START/STOP
PAUSE
REW 
INSERT
PLAY
STOP
T
W
START/STOP
INSERT
REW
PLAY
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops. ( pg. 84, 85)
●If a memory card is loaded and “NAVIGATION” is set to other than “MANUAL”, a NAVIGATION thumbnail image is stored in the memory card. ( pg. 48)
Random Assemble Editing [R.A.Edit]
Create edited videos easily using your camcorder as the source player. You can select up to 8 “cuts” for automatic editing, in any order you like. R.A.Edit is more easily performed when the MBR
STOP
PAUSE
To perform Random Assemble Editing, use the optional
NOTES:
●Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 31, 41)
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections. ( pg. 22)
1Play back the tape, locate the
2Press REW (3) until the
3Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.) appear and the camcorder enters
4Press START/STOP to begin editing.
●Confirm the insert at the time code you checked in step 1.
●To pause editing, press START/STOP. Press it again to resume editing.
5To end Insert Editing, press START/STOP, then STOP (8).
NOTES:
●Program AE with special effects ( pg. 33) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
SHIFT
MBR SET