JVC GR-D200 manual Automatic Editing To VCR, Engage the Stop modes for the camcorder and the VCR

$"￿EN USING THE REMOTE CONTROL UNIT (cont.)

Picture Wipe And Dissolve Menu (available only for Random Assemble Editing) You can use not only the wipe/fader effects on page 32 but also the picture wipe and dissolve effects below.

DISSOLVE: The new scene gradually appears as the old one gradually disappears.

WIPE – CORNER: The new scene wipes in over the previous one from the upper right corner to the lower left corner.

WIPE – WINDOW: The next scene gradually wipes in from the center of the screen toward the corners, covering the previous scene.

WIPE – SLIDE: The next scene gradually wipes in over the previous one from right to left.

WIPE – DOOR: The previous scene wipes out from the center to the right and left, like a door being pushed open to reveal the next scene.

WIPE – SCROLL: The new scene wipes in over the last one from the bottom of the screen to the top.

WIPE – SHUTTER: The new scene wipes in over the previous one from the center toward the top and bottom of the screen.

Automatic Editing To VCR

PAUSE

R.A.EDIT

ON/OFF

VCR REC STBY

RM-V717U (optional)

13Rewind the tape in the camcorder to the beginning of the scene you want to edit and press PAUSE (9).

14Press VCR REC STBY (79), or manually engage the VCR’s Record-Pause mode.

15Press the Recording Start/Stop Button on the camcorder. Editing proceeds as programmed, right through to the end of the last registered scene.

●When dubbing is complete, the camcorder enters the Pause mode, and the VCR enters its Record-Pause mode.

●If you do not register an Edit-Out point, the tape will be dubbed all the way to the end automatically.

●If you operate the camcorder during automatic editing, the VCR will enter its Record-Pause mode and automatic editing will stop.

16Engage the Stop modes for the camcorder and the VCR.

To make the R.A.Edit counter display disappear, press R.A.EDIT ON/OFF on the remote control.

NOTES:

●Pressing R.A.EDIT ON/OFF on the remote control clears all settings registered during Random Assemble Editing.

●When the editing cable is connected to the remote control’s PAUSE IN connector during dubbing, make sure the remote control is pointed at the VCR’s sensor, and the path between the two is unobstructed.

●Random Assemble Editing may not function properly when using a tape including several duplicated time codes. ( pg. 19)