22 EN VIDEO PLAYBACK |
|
Shuttle Search | Blank Search |
Allows
1)During playback, press ¡ for forward search, or 1 for reverse search.
2)To resume normal playback, press 6.
●During playback, press and hold ¡ or 1. The search continues as long as you hold the button. Once you release the button, normal playback resumes.
●A slight mosaic effect appears on the display during Shuttle Search. This is not a malfunction.
ATTENTION:
During Shuttle Search, parts of the picture may not be clearly visible, particularly on the left side of the screen.
Helps you find where you should start recording in the middle of a tape to avoid time code interruption. ( pg. 20)
1 Load a cassette. ( pg. 18)
2
3 Set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
4 Press BLANK.
●The “BLANK SEARCH” indication appears and the camcorder automatically starts reverse or forward search, then stops at the spot which is about 3 seconds of tape before the beginning of the detected blank portion.
●To cancel Blank Search, press 7 or BLANK.
NOTES:
●Before starting Blank Search, if the current position is at a blank portion, the camcorder searches in the reverse direction. If the current position is at a recorded portion, the camcorder searches in the forward direction.
●If the beginning or end of the tape is reached during Blank Search, the camcorder stops automatically.
●A blank portion which is shorter than 5 seconds of tape may not be detected.
●The detected blank portion may be located between recorded scenes. Before you start recording, make sure there is no recorded scene after the blank portion.