12 EN VIDEO PLAYBACK
MMENU/VOL. | Shuttle Search |
| BLANK SEARCH |
| Allows |
| playback. |
| 1) During playback, press 5 for forward search, or |
| 3 for reverse search. |
| 2) To resume normal playback, press 4/9. |
| ● During playback, press and hold 5 or 3. The search |
| continues as long as you hold the button. Once you release |
| the button, normal playback resumes. |
| ● A slight mosaic effect appears on the display during Shuttle |
| Search. This is not a malfunction. |
Power Switch
Lock Button
8
4/9
ATTENTION:
During Shuttle Search, parts of the picture may not be clearly visible, particularly on the left side of the screen.
|
| Blank Search |
|
| Helps you find where you should start recording in the |
|
| middle of a tape to avoid time code interruption. |
|
| ( pg. 11) |
|
| 1 Load a cassette. ( pg. 9) |
|
| 2 Set the Power Switch to “PLAY” while pressing down |
|
| the Lock Button located on the switch. |
|
| 3 During Stop mode, press BLANK SEARCH. |
|
| ● The “BLANK SEARCH” indication appears and the |
| 3 | camcorder automatically starts reverse or forward search, |
|
| then stops at the spot which is about 3 seconds of tape |
Speaker | 5 | before the beginning of the detected blank portion. |
|
| ● To cancel Blank Search midway, press 8. |
Normal Playback
1 Load a cassette. ( pg. 9)
2 Set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
3 To start playback, press 4/9.
4
●During Stop mode, press 3 to rewind, or 5 to fast- forward the tape.
To control the speaker volume
Rotate the MMENU/VOL. Wheel towards “+” to turn up the volume, or towards
NOTES:
●The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV. ( pg. 13)
●For other notes, pg. 27.
Still Playback
Pauses during video playback.
1)Press 4/9 during playback.
2)To resume normal playback, press 4/9 again.
●If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically engaged.
●When 4/9 is pressed, the image may not pause immediately while the camcorder stabilises the still image.
NOTES:
●Before starting Blank Search, if the current position is at a blank portion, the camcorder searches in the reverse direction. If the current position is at a recorded portion, the camcorder searches in the forward direction.
●Blank Search does not work if “USE CLEANING CASSETTE” has appeared with the tape.
●If the beginning or end of the tape is reached during Blank Search, the camcorder stops automatically.
●A blank portion which is shorter than 5 seconds of tape may not be detected.
●The detected blank portion may be located between recorded scenes. Before you start recording, make sure there is no recorded scene after the blank portion.