JVC GR-D47 manual Manual Focus, Auto Focus

FEATURES FOR RECORDING EN 21

	FOCUS	Manual Focus
SNAPSHOT		NOTE:
		If you are using the viewfinder, you should already have
MMENU/VOL.		performed “Viewfinder Adjustment” ( pg. 8).
		1 Set the Power Switch to “M”	While focusing on a
		while pressing down the Lock	further subject
Lock Button		Button located on the switch.
		2 Press FOCUS. The manual
		focus indicator appears.
		3 To focus on a further subject,
	Power Switch	rotate the MMENU/VOL. Wheel
		towards “+”. The “ ” indicator
		appears and blinks.	Manual focus indicator

Auto Focus

The camcorder’s Full Range AF system offers continuous shooting ability from close-up (as close as approx. 5 cm to the subject) to infinity.

However, correct focus may not be obtainable in the situations listed

To focus on a nearer subject, rotate the MMENU/VOL. Wheel towards “–”. The “ ” indicator appears and blinks.

To reset to Auto Focus Press FOCUS twice or set the Power Switch to “A”.

If FOCUS is pressed once, the camcorder will enter the focus

While focusing on a nearer subject

below (in these cases perform “Manual Focus”):

Focus detection zone

adjustment mode again.

NOTES:

Manual focus indicator

●When two subjects overlap in the same scene.

●When illumination is low.*

●When the subject has no contrast (difference in brightness and darkness), such as a flat, one-colour wall, or a clear, blue sky.*

●When a dark object is barely visible in the LCD monitor or the viewfinder.*

●When the scene contains minute patterns or identical patterns that are regularly repeated.

●When the scene is affected by sunbeams or light reflecting off the surface of a body of water.

●When shooting a scene with a high-contrast background. * The following low-contrast warnings appear blinking: ,

, and

NOTES:

●If the lens is smeared or blurred, accurate focusing is not possible. Keep the lens clean. (
pg. 34) When condensation occurs, wipe with a soft cloth or wait for it to dry naturally.

●When shooting a subject close to the lens, zoom out first. (
pg. 10) If zoomed-in in the auto focus mode, the camcorder may automatically zoom out depending on the distance between the camcorder and the subject. This will not occur when “TELE MACRO” is set to “ON”. (
pg. 15)

●Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you focus in on a subject in the wide-angle position, sharply focused images cannot be obtained when zoomed up because the depth- of-field is reduced at longer focal lengths.

●When the focus level cannot be adjusted any further or closer, “ ” or “ ” will blink.

ADVANCED FEATURES