6 EN GETTING STARTED
How To Attach The Core Filter (for optional S-Video Cable)
Attach the core filters to the cables. The core filter reduces interference.
1 Release the stoppers on both ends of the core filter.
Stopper 
2 Run the cable through the core filter, leaving approx. 3 cm of cable between the cable plug and the core filter. Wind the cable once around the outside of the core filter
Power
Power Switch
POWER/CHARGE lamp
Lock Button
Battery pack 
mount
as shown in the illustration.
To DC connector
Arrow
●Wind the cable so that it is not slack.
3 cm
Wind once.
3 Close the core filter until it clicks shut.
NOTES:
●Take care not to damage the cable.
●When connecting a cable, attach the end with the core filter to the camcorder.
Mark
Battery pack
BATT.RELEASE
AC Adapter
Power Cord
To AC outlet
This camcorder’s
Charging The Battery Pack
1 With the arrow on the battery pack pointing upward, push the battery pack slightly against the battery pack mount a.
2 Slide up the battery pack until it locks in place b.
3 Set the Power Switch to “OFF (CHARGE)”.
4 Connect the AC Adapter to the camcorder, then connect the Power Cord to the AC Adapter.
5 Plug the AC Adapter into an AC outlet. The POWER/ CHARGE lamp on the camcorder blinks to indicate charging has started.
6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
To detach the battery pack
Slide the battery pack down slightly while sliding BATT. RELEASE to detach it.
Battery pack | Charging time |
|
|
Approx. 1 hr. 30 min. | |
|
|
Approx. 3 hr. | |
|
|
Approx. 5 hr. | |
|
|
* Provided |
|
NOTES:
●If the protective cap is attached to the battery pack, remove it first.
●During charging, the camcorder cannot be operated.
●Charging is not possible if the wrong type of battery is used.