| EDITING EN 25 | |
Dubbing To Or From A Video Unit | To use this camcorder as a player | |
1 Make sure all units are turned off. | ||
Equipped With A DV Connector (Digital | ||
2 Connect this camcorder to a video unit equipped with | ||
Dubbing) | a DV input connector using a DV cable as shown in the | |
illustration. | ||
It is also possible to copy recorded scenes from the | 3 Set this camcorder’s Power Switch to “PLAY” while | |
camcorder onto another video unit equipped with a DV | pressing down the Lock Button located on the switch. | |
connector. Since a digital signal is sent, there is little if | 4 Turn on the video unit’s power. | |
any image or sound deterioration. | ||
5 Insert the source cassette in this camcorder. | ||
| ||
| 6 Insert the recording cassette in the video unit. | |
| 7 Press 4/9 on this camcorder to start playback of the | |
| source cassette. | |
| 8 At the point you want to start dubbing, engage the | |
| video unit’s Record mode. | |
| 9 To pause dubbing, engage the video unit’s Record- | |
| Pause mode and press 4/9 on this camcorder. | |
| 10 Repeat steps 7 – 9 for additional editing. Stop the | |
| video unit and camcorder. |
To DV IN/OUT
NOTES:
Core filter 
DV cable (optional)
To DV IN/OUT
●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 7)
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 8. If this occurs, turn off the power and make connections again.
●If SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV connector.
●When using a DV cable, be sure to use the optional JVC
ADVANCED FEATURES
Video unit equipped with DV connector
To use this camcorder as a recorder
1)Perform steps 1 to 3 in “To use this camcorder as a player”.
2)Set “REC MODE” to “SP” or “LP”. ( pg. 14, 15)
3)Insert the recording cassette in this camcorder.
4)Press the Recording Start/Stop Button to engage the
● The “ DV. IN ” indication appears on the screen.
5)Press the Recording Start/Stop Button to start recording. The T indication rotates.
6)Press the Recording Start/Stop Button again to stop recording. The T indication stops rotating.
NOTE:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 15)