JVC GR-D338AH manual Date/Time Settings, Viewfinder Adjustment, Brightness Adjustment, Display

Adjust the velcro strip.

GETTING STARTED EN 15

Date/Time Settings

The date/time is recorded onto the tape at all times, but its display can be turned on or off during playback. (
pg. 24)

1 Perform steps 1 – 4 in “Language Settings” (
pg. 14).

2 Press 3 or 4 to select “CLOCK ADJ.”, and press SET or 2. The date display format is highlighted.

3 Press 3 or 4 to select the desired date display format, then press SET or 2. Select from “MONTH.DATE.YEAR”, “DATE.MONTH.YEAR” or “YEAR.MONTH.DATE”.

4 Press 3 or 4 to select the time display format, then press SET or 2. Select from “24h” or “12h”.

5 Set the year, month, day, hour and minute. Press 3 or 4 to select the value, then press SET or 2. Repeat this step until you have input all the settings.

NOTE:

Press 1 to MENU return to the previous setting.

6 Press MENU.The Menu

Viewfinder Adjustment

1 Set the Power Switch to “REC” while pressing down the Lock Button located on the switch.

2 Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully and adjust it manually for best viewability.

3 Turn the Diopter Adjustment Control until the indications in the viewfinder are clearly focused.

Example:

GETTING STARTED

Diopter Adjustment Control

CAUTION:

When retracting the viewfinder, take care not to pinch your fingers.

Brightness Adjustment Of The

screen closes.

D I SPLAY

Display

CLOCK ADJ .

MONTH . DATE . YEAR 24h 1 . 1 . 2 0 06

13 : 00

Grip Adjustment

1

2 Pass your right hand through the loop and grasp the grip.

3 Adjust your thumb and fingers through the grip to easily operate the Recording Start/Stop

1 Set the Power Switch to “REC” or “PLAY” while pressing down the Lock Button located on the switch.

2 Open the LCD monitor fully. (
pg. 17)

÷To adjust the brightness of the viewfinder, pull out the viewfinder fully and set “PRIORITY” to “FINDER” (
pg. 23, 24).

3 Press MENU. The Menu Screen appears. If you are in Playback mode, please proceed to Step 5.

MENU

BRIGHT –1

Button, Power Switch and Power Zoom Lever. Be

sure to fasten the velcro strip to your preference.

4 Press 3 or 4 to select “DISPLAY”, and press SET or >. The DISPLAY Menu appears.

5 Press 3 or 4 to select “BRIGHT”, and press SET or 2. The Menu Screen closes and the brightness control indicator appears.

6 Press 3 or 4 until the appropriate brightness is reached and press SET or 2.

7 Press MENU. The menu screen closes.