|
|
| EN 79 |
P | SYMPTOM | POSSIBLE CAUSES | CORRECTIVE ACTION |
aAn unusual mark appears. |
| • Check the section of the manual | |
|
| that explains LCD monitor/ | |
|
| viewfinder indications | |
|
|
| |
|
|
| ( pg. 84 – 88). |
|
|
|
|
| An error indication | • A malfunction of some kind has | • Remove the power supply (battery |
s(E01, E02 or E06) appears. | occurred. In this case the | pack, etc.) and wait a few minutes | |
|
| camcorder’s functions become | for the indication to clear. When it |
|
| unusable. | does, you can resume using the |
|
|
| camcorder. If the indication |
|
|
| remains even though you repeat |
|
|
| the above two or three times, |
|
|
| please consult your nearest JVC |
|
|
| dealer. Do not eject the cassette. |
|
|
| This will cause damage to the tape. |
|
|
|
|
| An error indication | • A malfunction of some kind has | • Eject the cassette once and re- |
d(E03 or E04) appears. | occurred. In this case the | insert it, then check if the indication | |
|
| camcorder’s functions become | clears. When it does, you can |
|
| unusable. | resume using the camcorder. If the |
|
|
| indication remains even though you |
|
|
| repeat the above two or three |
|
|
| times, please consult your nearest |
|
|
| JVC dealer. |
|
|
|
|
| The charger indicator on | • The temperature of the battery is | • To protect the battery, it is |
| the AC Power Adapter/ | extremely high/low. | recommended to charge it in |
fCharger does not light. | • Charging is difficult in places | places with a temperature of 10°C | |
|
| subject to extremely high/low | to 35°C (50°F to 95°F) ( pg. 89). |
|
| temperatures. |
|
|
|
|
|
| Picture does not appear on | • The viewfinder is pulled out. | • Push the viewfinder back in. |
gthe LCD monitor. | • The LCD monitor’s brightness | • Adjust the brightness of the LCD | |
|
| setting is too dark. | monitor ( pg. 18). |
|
|
| • If the monitor is tilted upward 180 |
|
|
| degrees, open the monitor fully |
|
|
| ( pg. 18). |
|
|
|
|
| When the image is printed | • This is not a malfunction. | • By recording with “DIS” activated |
| from the printer, a black bar |
| ( pg. 29) this can be avoided. |
| appears at the bottom of |
|
|
hthe screen.
When the camcorder is | • The DV cable was plugged/ | • Turn the camcorder’s power off and |
connected via the DV | unplugged with power turned on. | on again, then operate it. |
connector, the camcorder |
|
|
jdoes not operate. |
|
|
|
|
|
The memory card cannot |
| • Push in the memory card a few |
be removed from the | more times ( pg. 13). | |
camcorder. |
|
|