JVC GR-AXM710 manual Connection EN53, Connection to a Windows PC, Connect to Personal Computer

D.S.C.PLAYBACK

ConnectionEN53

Connection to a Windows® PC

	Image data stored in the camcorder’s built-in memory can
	be transferred to a Windows® PC and saved using the
Set to “D.S.C.”	provided image transfer software, Picture Navigator. The
	image data transferred to a Windows® PC can also be
	further processed using Mr. Photo Gold, and the still image
	processed on the PC can be inserted onto a tape
	(☞ pg. 63).
	To assure safety, make sure all units are turned off before
	making any connection.

To DIGITAL connector

PC connection cable (provided)

For Windows®: To COM Port (RS-232C)

Display

PCMODE

NOTES:

1 CONNECT TO PERSONAL COMPUTER

Connect the camcorder’s DIGITAL connector to the COM Port (RS-232C) on a Windows® PC, using the provided PC connection cable.

2 SELECTMODE OPERATION SYSTEM AND

Set the System Select Switch to “D.S.C.”, then set the Power Switch to “PLAY”.

•A still image stored in memory appears. •When transferring still images to a computer, be

sure that a still image is displayed on the screen.

3 RUN IMAGE TRANSFER SOFTWARE Launch the provided software on your Windows® PC. Transfer the still images stored in the camcorder’s memory to the Windows® PC. Refer to the software’s instruction manual on the provided CD-ROM for details.

•During transfer of the still image, the camcorder’s

screen becomes blue and “ ” is dis- played. After transferring is finished, the screen displays the same still image as in step 2.

4 END TRANSFERRING

Close the software, then switch off the camcorder.

●Before transferring still images from your personal computer to the camcorder’s built-in memory, perform the camcorder’s Picture Mode Setting (☞ pg. 24). The still images will be transferred from the personal computer in the selected Picture Mode.

●When transferring still images from your personal computer to the camcorder, make sure the number of images to be transferred is smaller than the camcorder's remaining number of shots available.

●Use the AC Power Adapter/Charger as the power supply instead of the battery pack.

●The still images stored in the camcorder’s memory are not automatically removed after being transferred to the PC. If you wish to remove those still images from the camcorder's memory, delete them (☞ pg. 58, 59).

●Windows® are trademarks of Microsoft Corporation, registered in the U.S.A. and other countries.