JVC GR-AXM710 manual When the System Select Switch is set to D.S.C

68ENTROUBLESHOOTING

(cont.)

When the System Select Switch is set to “D.S.C.”:

SYMPTOM	POSSIBLE CAUSE(S)
SHOOTING
Although the SNAPSHOT Button is	● When the number of remaining shots available reaches “0”
pressed, a still image is not stored in	(blinking), it becomes impossible to take your next shot.
the built-in memory.	Perform “DELETE” function to remove some still images
	already stored in memory (☞ pg. 58).
Self-Timer Shooting is not available.	● Pressing the Recording Start/Stop Button does not start
	recording in the Self-Timer Shooting procedure. Press the
	SNAPSHOT Button (☞ pg. 44).

It is not possible to shoot in sucession.

●A still image is in the process of being stored in memory for approx. 2 seconds after the SNAPSHOT Button is pressed. During that time, it is impossible to take another shot. When the still image disappears and the scene you are currently aimed at appears on the screen, take another shot (☞ pg. 22).

PLAYBACK

Although “ALL” is selected in the DELETE Menu Screen, all still images cannot be deleted.

OTHER

●The “Protect” function is in effect for some still images. If they are not necessary, cancel the “Protect” function, then try deleting all still images again (☞ pg. 57).

Date/Time Insert is not performed	● It is not possible to display the date/time on a still image.
while shooting a still image.
Instant Titles are not displayed while	● It is not possible to display the Instant Titles on a still image.
shooting a still image.
Some settings cannot be changed in	● It is not possible to set “REC TIME” in the Menu Screen.
the Menu Screen.

Since the camcorder is a microcomputer-controlled device, external noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. For example, when a still image you shot is stored in the camcorder's built-in memory, the above may cause the following: Although the remaining number of shots indicator shows that shooting is possible, a still image cannot be stored in memory after shooting. In such a case, initialize the memory by following steps 1 through 3 below. Please note that initialization deletes all the still images (including ones for which you performed the “Protect” function) stored in the camcorder’s memory. If you wish to keep any of the still images that are stored in memory, before initialization first transfer them to a PC and save them. If image data is corrupt, transfer is impossible.

FORMAT

CANCEL

ENTER

FORMAT Menu

1.Set the System Select Switch to “D.S.C.”, then set the Power Switch to “PLAY”.

2.Press the SP/EP Recording Mode Button for more than 2 seconds. The FORMAT Menu Screen appears.

3.Rotate the Select Dial to move the highlight bar to “CANCEL” or “ENTER”, then press it.

•“CANCEL” does not initialize the memory.

•“ENTER” initializes the memory. During initialization, “ENTER” blinks. When initialization is complete, the screen becomes blue back.

CAUTION:

While “ENTER” is selected and it is blinking, switching off the camcorder or removing the power supply unit (battery pack or AC Power Adapter/Charger) may cause the camcorder’s built-in memory to become corrupt. Never remove the power supply unit at this stage.