JVC GR-AXM710 manual During use, Store cassettes, For safety, do not, Avoid using the unit

Page 75

Cassettes

To properly use and store your cassettes, be sure to read the following cautions:

1. During use . . .

... make sure the cassette bears the VHS-C mark.

... be aware that recording onto prerecorded tapes automatically erases the previously recorded video and audio signals.

... make sure the cassette is positioned properly when inserting.

... do not load and unload the cassette repeatedly without allowing the tape to run at all. This slackens the tape and can result in damage.

... do not open the front tape cover. This exposes the tape to fingerprints and dust.

2. Store cassettes . . .

... away from heaters or other heat sources.

... out of direct sunlight.

... where they won’t be subject to unnecessary shock or vibration.

... where they won’t be exposed to strong magnetic fields (such as those generated by motors, transformers or magnets).

... vertically, in their original cases.

EN75

Main Unit

1. For safety, DO NOT . . .

... open the camcorder’s chassis.

... disassemble or modify the unit.

... short-circuit the terminals of the battery pack. Keep it away from metallic objects when not in use.

... allow inflammables, water or metallic objects to enter the unit.

... remove the battery pack or disconnect the power supply while the power is on.

... leave the battery pack attached when the camcorder is not in use.

2. Avoid using the unit . . .

... in places subject to excessive humidity or dust.

... in places subject to soot or steam such as near a cooking stove.

... in places subject to excessive shock or vibration.

... near a television set.

... near appliances generating strong magnetic or electric fields (speakers, broadcasting antennas, etc.).

... in places subject to extremely high (over 40°C or 104°F) or extremely low (under 0°C or 32°F) temperatures.

3. DO NOT leave the unit . . .

... in places of over 50°C (122°F).

... in places where humidity is extremely low. (below 35%) or extremely high (above 80%).

... in direct sunlight.

... in a closed car in summer.

... near a heater.

4.To protect the unit, DO NOT . . .

... allow it to become wet.

... drop the unit or strike it against hard objects.

... subject it to shock or excessive vibration during transportation.

... keep the lens directed at extremely bright objects for long periods.

... direct the eyepiece of the viewfinder at the sun.

... carry it by holding the viewfinder or the LCD monitor. Be sure to hold the main unit with both hands or use the grip.

... swing it excessively when using the shoulder strap.

Image 75
Contents Model No Serial No For Customer UseFor clock operation and remote control unit Dear CustomerIt is recommended that you Grounding or Polarization Power SourcesPower Cord Protection Power LinesReplacement Parts AccessoriesCleaning Damage Requiring ServiceCassettes marked can be used with this camcorder Zoom Zoom outImage you shoot is recorded onto a video tape Using the battery packTo remove the battery pack Slide Battery Release and pull out the battery packQuick Operation Guide D.S.C. EN7 Snapshot ButtonOpen/Close Ring Set to Auto or PRO Contents Software programs Cassette AdapterVHS Playpak C-P7U BN-V20U Shoulder Strap DC Cord Unit RM-V705U For Windows PCPower Charging the Battery PackUsing the Battery Pack Choose which one means charged and which means discharged Using AC PowerUsing a CAR Battery Charge MarkerGetting Started Clock Lithium Battery Insertion/RemovalDate/Time Settings Cont Recording Mode SettingTape Length Setting EN Getting StartedClose Cassette Holder Loading/Unloading a CassetteOpen LCD Monitor Open Cassette HolderViewfinder Adjustment Grip AdjustmentAttach Strap Adjust LengthShoulder Strap Attachment Tripod MountingStart Shooting Power Switch PositionBasic Recording Load a CassettePress Display Button Tape remaining time indicatorLCD Monitor/Viewfinder Indications Stop RecordingPower Switch Recording Start/Stop Button Power lamp Tally lamp Lights while recording is in progressBefore the following steps, perform pg Journalistic Shooting Interface ShootingBrightness Control Mode Selection Basic ShootingStill Image Storage Snapshot mode with no frame Motor Drive modeRemaining number of shots 30 29 1 Normal Screen Feature Picture Mode SettingSnapshot Button System Select Switch Menu Button Picture mode displayEN25 Recording Basic Features Snapshot Mode SelectionSnapshot If you press during Record-Standby mode Snapshot RecordingDisplay ex. Pin-Up Basic Features Push the Power Zoom Lever towards TZoom To re-record certain segments Feature Quick ReviewFeature Picture Stabilizer To check the end of the last recordingFeature Video Light To brighten the scene when natural lighting is too dimLight OFF/AUTO/ON Switch Fade/Wipe Advanced Features EN31Press P.AE to cycle through the modes as shown on the left Advanced FeaturesSelect Mode Program AE With Special EffectsND Effect SepiaSports TwilightAutomatically Recording Advanced FeaturesDate/Time Insert Monitor, as well as to record them manually orInstant Titles Access Title MenuSystem Select Switch Select Dial Display Power Switch Menu Screen Title MenuSystem Select Switch Select Dial Menu Button Using Menu For Detailed AdjustmentMake Setting END SettingMenu Screen Available Using The Select Dial Menu Screen Available Using The Menu ButtonMenu Screen Explanations Tally lamp comes on to signal the start of recording Maximum telephoto setting. When set to ON, you can shoot aDisplayed with the System Select Switch set to either Video Displayed only with the System Select Switch set to D.S.CAccess Exposure Menu Exposure ControlTo darken the image Patterns that are regularly repeated FocusingRecording Auto FocusManual Focus Access Focus MenuAccess Manual Focus END Adjustment of FocusTo Return To Automatic White Balance White Balance AdjustmentAccess White Balance Adjustment SET Function ParametersTo Change The Tint For Recording Enter SettingManual White Balance Operation Press the Select Dial again to close the Menu ScreenIf you set the System Select Switch to Video Self-TimerAccess INT. Time Menu Start Delayed RecordingTime-Lapse AnimationStop Playback Video Playback Basic PlaybackRewind or Fast-Forward the tape Play BackTracking Video Playback Features EN47Speaker Volume Control Adjust VolumeFeature Counter Memory Function EN Video Playback FeaturesFeature Still Playback Feature Shuttle SearchCassette Adapter VHS Playpak Video Playback Using The Cassette Adapter EN49Insert Battery Recording safety holeConnection For Tape Dubbing When connecting the cables, open this coverBasic Connections And Tape Dubbing Basic ConnectionsTape Dubbing C. Playback Basic Playback Becomes blueTo move Back END Transferring Connection EN53Connection to a Windows PC Connect to Personal ComputerIf you select any other functions C. Playback Advanced FeaturesProtect pg , Delete pg , 59 and do each procedure from step Slide-show will start pgMode Effect Never remove the power supply unit at this stageMenu Screen Explanations Playback Screen Access Index MenuIndex View Index ImagesWay To complete Protect, go to step Access Protect MenuProtect SET ProtectDelete Access Delete MenuSelect Delete Mode To quit the Delete ModeX T Delete Access Delete Execute MenuFunctions Installing The BatteryPull OUT Battery Holder Remote control uses one lithium battery CR2025Time-Lapse Feature Self-Timer, Animation and Time-LapseSelf-Timer AnimationInsert Editing Video EN Using the Remote Control UnitPress REW 2/PAGE- or FF 3/PAGE+ to move the page forward Built-in Memory Onto a TapeSelect Still Image To insert still images in sequential order onto the tapeRemote sensor Microphone Set to Video Audio DubbingBegin Audio Dubbing END Audio DubbingAfter Use Cleaning The CamcorderNot appear No power is suppliedSome functions are not available During recording, the indications doWhen the System Select Switch is set to Video When the System Select Switch is set to D.S.C Tape Remaining Time Zoom Level Indicator Approximate Zoom RatioInterval Timer/Recording Time Indicator Clock Battery Warning70EN Index Controls, Connectors And IndicatorsRecording Mode Button SP/EP Video Light SwitchSystem Select Switch MENU/DISPLAY Button Counter Reset/Memory ButtonDigital Still Camera Index TermsPg , 57 ShootingPlug adapter To prevent damage and prolong service lifeTo avoid hazard Do not burnStore cassettes For safety, do notAvoid using the unit During useSerious malfunctioning To prolong service lifeTo prevent damage to the LCD monitor, do not About moisture condensationConnectors Provided Accessories Optional AccessoriesGeneral USO DE LA Bateria AlimentaciónAtencion Carga DE LA BateriaPara extraer la batería Deslice Battery Release y extraiga la bateríaGuia Para Operacion Rapida Vodeo EN79 Utilización de la bateríaBotón Snapshot Por más detalles, p aPor más detalles, p Botón REW 2/PAGE FF 3/PAGE +For Servicing Only in U.S.A. EN81 HOW to Locate Your JVC Service CenterEN Warranty Only in U.S.A Memo EN83 GR-AXM710