JVC GR-DVL765 specifications Menu Screen Explanations

						EN 47
Menu Screen Explanations
		WIPE/FADER			Refer to “Fade/Wipe Effects” ( pg. 40, 41).
			PROGRAM AE		Refer to “Programme AE With Special Effects” ( pg. 38, 39).
			EXPOSURE		Refer to “Exposure Control” and “Iris Lock” ( pg. 44).
		W.BALANCE			Refer to “White Balance Adjustment” and “Manual White Balance Operation”
					( pg. 45).
			REC MODE		Allows you to set the tape recording mode (SP or LP) depending on your
					preference ( pg. 13).
			SOUND	12BIT	Enables tape recording of stereo sound on four separate channels, and is
			MODE		recommended for use when performing audio dubbing. (Equivalent to the
					32 kHz mode of previous models)
				16BIT	Enables tape recording of stereo sound on two separate channels. (Equivalent
					to the 48 kHz mode of previous models)
			ZOOM	10X	When set to “10X” while using digital zoom, the zoom magnification will reset to
					10X since digital zoom will be disengaged.
	CAMERA
				40X	Allows you to use the Digital Zoom. By digitally processing and magnifying
					images, zooming is possible from 10X (the optical zoom limit), to a maximum
					of 40X digital magnification.
				500X	Allows you to use the Digital Zoom. By digitally processing and magnifying
					images, zooming is possible from 10X (the optical zoom limit), to a maximum
					of 500X digital magnification.
			SNAP MODE		Refer to “Snapshot (For Tape Recording)” ( pg. 42).
			GAIN UP	OFF	Allows you to shoot dark scenes with no picture brightness adjustment.
				AGC	The overall appearance may be grainy, but the image is bright.
				AUTO	The shutter speed is automatically adjusted (1/25 — 1/200 sec.). Shooting a
					subject in low or poor lighting at 1/25 sec. shutter speed provides a brighter
					image than in the AGC mode, but the subject’s movements are not smooth or
					natural. The overall appearance may be grainy. While the shutter speed is
					being automatically adjusted, “ ” is displayed.
			DIS	OFF	To compensate for unstable images caused by camera-shake, particularly at
					high magnification.
					NOTES:
	MANUAL			ON	● Accurate stabilisation may not be possible if hand shake is excessive, or
					• When shooting dark or dim subjects.
					under the following conditions:
					• When shooting subjects with vertical or horizontal stripes.
					• When shooting subjects with excessive backlighting.
					• When shooting scenes with movement in various directions.
					• When shooting scenes with low-contrast backgrounds.
					● Switch off this mode when recording with the camcorder on a tripod.
					● The “	” indicator blinks or goes out if the Stabiliser cannot be used.
			: Factory-preset

NOTES:

			AUTO	MANUAL	”.
● Settings made in the “ CAMERA” Menu remain effective whether the Power Switch is set to “				” or “
However, the menu settings can be changed only when the Power Switch is set to “			”.
	MANUAL
● The “	MANUAL” settings are effective only when the Power Switch is set to “	”.
	MANUAL

CONTINUED ON NEXT PAGE