JVC GR-SXM25 manual Begin Audio Dubbing, END Audio Dubbing

Display
	Audio dubbing
e4
M 0 : 05 : 20	indicator

Remote sensor

Microphone

EN47

Audio Dubbing

You can record a new soundtrack on a prerecorded tape (normal audio only).

Perform steps 1, 2 and 3 of the Insert Editing procedure (☞ pg. 46) before continuing.

•The sound comes from the built-in microphone.

1 FIND EDIT-IN POINT

Press REW to go a little beyond the beginning of the scene onto which you want to dub the new audio, press PLAY to view the recorded tape, then press PAUSE at exactly the point where dubbing should start.

2 ENGAGE AUDIO DUB-STANDBY MODE Press and hold A. DUB, and without releasing

A. DUB, press and release PAUSE.

3 BEGIN AUDIO DUBBING

Press PLAY. When the counter reaches “0:00:00”, Audio Dubbing stops automatically and the camcorder enters the Audio Dub-Standby mode.

4 END AUDIO DUBBING

Press STOP.

NOTES:

REW

A. DUB

STOP

● Do not press FF or REW during Audio Dub-Standby, or

the edit points will not be accurate.

● If the microphone is too close to the TV, or if the TV’s

PLAY

PAUSE

RM-V700U (optional)

volume is too high, whistling or howling may occur.

NOTES (for Insert Editing and Audio Dubbing):

●Insert Editing and Audio Dubbing may not work correctly if the tape contains blank segments, or if the recording speed was changed during the original recording.

●To edit/dub onto a tape, make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.

●Do not press STOP during Insert Editing or Audio Dubbing, or the edit points will not be accurate.

●During Insert Editing and Audio Dubbing, when Insert- Pause or Audio Dub-Standby is engaged, the counter may go slightly past “0:00:00”. Recording, however, stops at exactly 0:00:00.