JVC GR-SXM760A specifications Shooting, When the System Select Switch is set to D.S.C

		EN59
When the System Select Switch is set to “D.S.C.”:
	SYMPTOM	POSSIBLE CAUSE(S)
	SHOOTING
	Although SNAPSHOT is pressed, a still	● When the number of remaining shots available reaches “0”
	image is not stored in the built-in	(blinking), it becomes impossible to take your next shot.
	memory.	Perform “DELETE” function to remove some still images
		already stored in memory ( pg. 46).
	It is not possible to shoot in sucession.	● A still image is in the process of being stored in memory for
		approx. 2 seconds after SNAPSHOT is pressed. During that
		time, it is impossible to take another shot. When the still image
		disappears and the scene you are currently aimed at appears
		on the screen, take another shot ( pg. 16).
	PLAYBACK
	Although “ALL” is selected in the	● The “Protect” function is in effect for some still images. If they
	DELETE Menu Screen, all still images	are not necessary, cancel the “Protect” function, then try
	cannot be deleted.	deleting all still images again ( pg. 45).
	OTHER
	Date/Time Insert is not performed	● It is not possible to display the date/time on a still image.
	while shooting a still image.
	Instant Titles are not displayed while	● It is not possible to display the Instant Titles on a still image.
	shooting a still image.
	Some settings cannot be changed in the	● It is not possible to set “REC TIME” in the Menu Screen.
	Menu Screen.

Since the camcorder is a microcomputer-controlled device, external noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. For example, when a still image you shot is stored in the camcorder's built-in memory, the above may cause the following: Although the remaining number of shots indicator shows that shooting is possible, a still image cannot be stored in memory after shooting. In such a case, initialise the memory by following steps 1 through 3 below. Please note that initialisation deletes all the still images (including ones for which you performed the “Protect” function) stored in the camcorder’s memory. If you wish to keep any of the still images that are stored in memory, before initialisation first transfer them to a PC and save them. If image data is corrupt, transfer is impossible.

FORMAT

CANCEL

ENTER

FORMAT Menu

1.Set the System Select Switch to “D.S.C.”, then set the Power Switch to “PLAY”.

2.Press COUNTER R/M for more than 2 seconds. The FORMAT Menu appears.

3.Rotate the Select Wheel to move the highlight bar to “CANCEL” or “ENTER”, then press it.

•“CANCEL” does not initialise the memory.

•“ENTER” initialises the memory. During initialisation, “ENTER” blinks. When initialisation is complete, the screen becomes blue back.

CAUTION:

While “ENTER” is selected and it is blinking, switching off the camcorder or removing the power supply unit (battery pack or AC Power Adapter/Charger) may cause the camcorder’s built-in memory to become corrupt. Never remove the power supply unit at this stage.