Tape remaining time indicator
25MINMIN
(Now calculating)
120MIN
119MIN
3MIN
2MIN
(Blinking)
1MIN
(Blinking)
0MIN
(Blinking)
Start/Stop Button
EN17
STOP RECORDING
4 Press the Recording Start/Stop Button again to stop recording.
•The camcorder
NOTES:
●A cassette holder can’t be opened unless a power supply is attached.
●There may be a delay after you slide EJECT until the holder opens. Do not use force.
●The displayed remaining time is approximate.
●The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
●The tape remaining time indicator is correct only if the correct tape length has been selected (☞ pg. 14).
●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.
●If the
●If the Recording Start/Stop Button is pressed after the
5 minutes, recording may not start immediately.
●If you’re recording on a cassette from the middle (such
as when a tape is removed and
●The LENS COVER warning blinks for about 5 seconds when the camcorder is turned on when the cover is closed.