JVC LYT0089-001A Access R.A. Edit Counter Display, Register Beginning of Scene, Make Corrections

66EN

USINGREMOTECONTROLUNIT(cont.)

PLAY/PAUSE FF SELECT SCENES

STOP

REW

		RM-V709U
		(provided)
REW		FF
		PAUSE
PLAY
IN/OUT		ON/OFF
		CANCEL
	IN	OUT
1	0:00:25	-- : -- : --
2
3
4
5
6
7
8
COUNTER		0:00:25
TOTAL		0:00:00
	IN	OUT
1	0:00:25	0:01:05
2	0:03:18	0:03:31
3	0:02:33	0:02:53
4	0:04:11	-- : -- : --
5
6
7
8
COUNTER		0:04:11
TOTAL		0:01:13

ACCESS R.A. EDIT COUNTER DISPLAY

1 Press PLAY/PAUSE, then press ON/OFF and the counter display appears in the viewfinder and the screen of the connected TV.

REGISTER BEGINNING OF SCENE

2 Press REW or FF to locate the beginning of a scene you want, then press IN/OUT to register that point. The data appears under “IN” on the display.

REGISTER END OF SCENE

3 Press REW or FF to locate the end of the scene and press IN/OUT to register it. The data appears under “OUT” on the display. The total time of the registered scene(s) is displayed at the bottom of the screen.

REGISTER ADDITIONAL SCENES

4 Repeat steps 2 and 3 for each additional scene (as many as 8).

MAKE CORRECTIONS

5 Press CANCEL during steps 2 and 3 to erase the most recently registered point.

NOTES:

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, there should be at least 15 seconds between an out-point and the next in-point.

●Blank portions of tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing doesn’t take place.

●Pressing ON/OFF clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.