Grip Adjustment
1 Adjust the velcro strip.
2 Pass your right hand through the loop and grasp the grip.
3 Adjust your thumb and fingers to easily operate the recording start/stop button, power switch and zoom lever. Be sure to fasten the velcro strip to your preference.
Tripod Mounting
To attach the camera to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camera. Then tighten the screw clockwise.
●Some tripods are not equipped with studs.
GETTING STARTED EN 19
Inserting/Removing an SD Card
You can use an SD card as a recording medium | STARTED | |
Clipped Edge | ||
in the SD slot. See page 62 for the guaranteed |
| |
media to work with this camera. |
| |
SD Card (optional) | GETTING | |
Label | ||
| ||
Write/Erase |
| |
Protection Tab |
|
SD Card Cover [OPEN]
SD Slot
1 Make sure the camera’s power is off.
2 Open the SD card cover.
3 To insert an SD card, firmly insert it with its clipped edge first.
To remove an SD card, push it once. After the SD card comes out of the camera, pull it out.
●Do not touch the terminal on the reverse side of the label.
4 Close the SD card cover.
To protect valuable files
Slide the write/erase protection tab on the side of the SD card in the direction of “LOCK”. This prevents the SD card from being recorded over. To record on this SD card, slide the tab back to the position opposite to “LOCK” before inserting it.
NOTE:
Before using a new SD card, it is necessary to format the card. ( pg. 20)
ATTENTION:
Do not insert or remove the SD card while the camera is turned on, as this may cause the data on the SD card to be corrupted or cause the camera to become unable to recognise whether or not the SD card is installed.