Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC by connecting the camera and the PC. The software [LUMIX Simple Viewer] or
(for Windows®) in the
If you use “Windows 98/98SE”, install the USB driver and then connect it to the computer.
For information about the software in the
A: USB connection cable (supplied)
B: AC adaptor
•Use batteries with sufficient battery power (P23) or the AC adaptor
•Turn the camera off before inserting or removing the cable for the AC adaptor
•Set the camera to a mode other than [] mode.
1 Turn on the camera and the PC.
2 Connect the camera to a PC via the USB connection cable A (supplied).
•Connect the USB connection cable with the [ ] mark facing the [1] mark on the [DIGITAL] socket.
•Hold the USB connection cable at C and insert straight in or take straight out. (If you forcibly insert the USB connection cable at a slant or upside down you can deform the connection terminals and damage the camera or the connected equipment.)
ACCESS
D: This message appears during data transfer.
[Windows]
The drive appears in the [My Computer] folder.
•If you are connecting the camera to a PC for the first time, the required driver is installed automatically so that the camera can be recognized by “Windows Plug and Play”. The drive then appears on the [My Computer] folder.
[Macintosh]
The drive is displayed on the screen.
•The drive is displayed as [LUMIX] when you connect the camera with no card inserted.
•The drive is displayed as [NO_NAME] or [Untitled] when you connect the camera with a card inserted.
85
VQT1C39