Others
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there are no remaining folder numbers that can be used. (P86)
Format the card after saving necessary data on a PC etc. (P84)
If you execute [NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100. (P22)
[PICTURE IS DISPLAYED FOR 4:3 TV]/ [PICTURE IS DISPLAYED FOR 16:9 TV]
•The AV cable
•Select [TV ASPECT] in the [SETUP] menu to change the TV aspect. (P22)
•This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P85, 88)
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you change the mode dial to print mode [ ] while this unit and the PC are connected. If a printer is connected, change the mode to a mode other than [ ] mode and then check that no data is being transferred. ([ACCESS] appears on the LCD monitor of this unit while data is being transferred.)
[USB MODE CHANGED. PLEASE REMOVE THE USB CABLE.]
This message will be displayed if you change the mode dial to a mode other than print mode [ ] while this unit and the printer are connected.
Set the mode dial to [ ] again and then disconnect the USB connection cable. If printing, stop the printing and then disconnect the USB connection cable.
Troubleshooting
If you return the menu settings to the initial settings at the time of purchase, the condition may improve.
Select [RESET] in the [SETUP] menu. (P22)
∫Batteries and the power source
1: The camera turns off immediately even when battery power is full. The remaining battery power is low even if new batteries are inserted.
•The remaining battery power may not be displayed accurately, and the camera may suddenly stop working, when the type of battery and the settings on [BATTERY TYPE] are not identical. However this is not a malfunction. Depending on the battery brand and the operating temperature, or if exhausted batteries are used, the remaining battery power may not be displayed accurately.
–Please check [BATTERY TYPE] (P20) in the [SETUP] menu.
2:The camera cannot be operated even when it is turned on.
•Are the batteries inserted correctly?
•Use sufficiently charged batteries when using
3:The LCD monitor turns off while the camera is turned on.
•Is power save mode (P21) or economy mode (P21) activated?
–Press the shutter button halfway to cancel these modes.
•Are the batteries exhausted?
–Replace them with batteries which have sufficient capacity. (When you use
99
VQT1C39