Panasonic HX-A500 How to remove the battery, Remove the battery by using a screwdriver

Page 31

How to remove the battery

When disposing of your used products, perform [RESET Wi-Fi SETTINGS] to delete personal information from this unit.

This figure describes the disposal of this unit, it is not instruction for repair. If disassembled, repair is not possible.

≥Disassemble after the battery runs out.

≥If it cannot be removed smoothly, contact Panasonic’s Service Center.

≥Keep disassembled parts out of reach of children.

1Open the side cover, and remove all of the 6 screws indicated in the

figure below.

≥Use a cross-slot screwdriver (commercially available).

2Remove the connector A of the flexible circuit board, and remove the circuit board on the front side (button side) of this unit.

4Remove the 4 screws indicated in the figure below, and remove the heatsink D.



5Remove the connector E of the camera unit, the built-in battery connector F, and the NFC flexible circuit board G, and lift up the circuit board.









3Pull out the flexible circuit board B, and pull out the speaker connector C upwards.

6Remove the battery by using a screwdriver.

		Regarding the handling of used batteries
	 	≥ Insulate the terminals with cellophane tape or
	 	similar.
		similar.

≥Do not disassemble.

31

(ENG) SQT0251

Image 31

Contents Https//eww.pavc.panasonic.co.jp/hdw/oi/A500 Wearable CameraDear Customer FCC Note Following Applies only in the U.S.AImportant Safety Instructions Contains IC 772C-LBVX604 Contains FCC ID VPYLBVX532About connecting to a PC If you see this symbolContents Handling of this unit Important About the Waterproof/ DustproofClose the side cover securely Check before using underwaterOpen the side cover If there is foreign matter adhering to the unit, remove itCaring for this unit after using it underwater Using this unit underwaterRinse with water with the side cover closed Read this first Cards that you can use with this unit AccessoriesDLNA-compatible devices What you can do with this unitLive broadcasting Playback on DLNA-compatible devicesCharging the battery Power supplyCharging and recording time Battery capacity indicationCharging/Recording time Off When the Power lamp is flashing during chargingRecording to a card Cards that you can use with this unitInserting/removing a microSD card Check that the access lamp has gone off Access lampTo turn off this unit Setting date and timePress the power button to turn on this unit Turning this unit on/offPress the joystick Using the menu screenLanguage selection FormattingBefore recording Fastening the main unit using the Armband CaseWearing this unit Pass the band through the band hole About the Armband CaseCable holder Things to check after putting on this unit How to remove the cameraPress the joystick to select the menu Changing the Recording ModeRecording Press the recording start/stop buttonTap Playback using a smartphoneConnect your Android Connect your iOS Wi-FifunctionInstall the Image App This unit is NFC-compatibleStart up the smartphone application Image App Preparations before using remote operationIf the device is Android NFC-compatible If the device is Android non-NFC-compatible or iOSReset Wi-Fi settings If the Wi-Fi connection cannot be establishedSelect YES, then press the joystick It is not a malfunction in following cases TroubleshootingLong enough Keep removed screws etc. out of the reach of small children Requests when disposing of this unitBattery used for this unit This may cause leaking, overheating, fire or ruptureRemove the battery by using a screwdriver How to remove the batteryRegarding the handling of used batteries Specifications Operating humidity Optional accessoriesBattery operation time Wireless transmitterCarefully observe copyright Laws About copyrightLicenses ENG SQT0251 Visa Accessory Order Form For USA CustomersPanasonic Products Limited Warranty Limited Warranty only for U.S.AAs of April Warranty For Canadian Customers Panasonic Corporation of North America