Panasonic NV-GS300 To cancel Quick Start, ≥Set to Tape/Card Recording Mode

Page 13

Before using

Quick Start

When quick start is ON the battery power is still being consumed, even when the LCD monitor and the viewfinder are closed.

The movie camera will resume recording/pause mode about 1.7 seconds after the LCD monitor or the viewfinder is reopended.

≥Please note in quick start mode approximately half the pause recording power is being consumed. Using quick start mode will reduce the battery recording/playback time.

≥This is only activated in the following cases. ≥A tape or a card is inserted, while the Tape

Recording Mode is set.

≥A card is inserted, while the Card Recording Mode is set.

≥Set to Tape/Card Recording Mode.

1Set [SETUP] >> [QUICK START] >> [ON]. (-18-)

2While the [OFF/ON] switch is still set to [ON], close the LCD monitor and retract the viewfinder.

OFF

ON

≥The Status indicator lights green and the unit goes into quick start standby mode.

≥The lens cover does not close.

≥The movie camera will not go into quick start standby unless the LCD monitor is closed and the viewfinder is retracted.

3Open the LCD monitor or extend the Viewfinder.

OFF

ON

≥The Status indicator lights red and the camera is put into recording pause approx. 1.7 seconds after it is turned on.

ªTo cancel Quick Start

1Set [SETUP] >> [QUICK START] >> [OFF]. (-18-)

≥If the [OFF/ON] switch is set to [OFF] while the unit is in quick start standby, the lens cover closes and the power turns off.

≥If the standby continues for approx. 30 minutes, then the Status indicator will go off and the camera will be completely turned off.

≥If the Mode dial is moved or the battery is

removed in quick start standby mode, quick start is cancelled and the power turns off.

≥When the camera is quick-started with the white balance on automatic, it may take some time until the white balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the colour night view function is used, however, the white balance of the scene last recorded is retained.)

≥If the power is turned on in quick start standby, the zoom magnification becomes 1k and the picture size may differ from what it was before quick start standby.

≥If [POWER SAVE] (-52-) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, set the [OFF/ON] switch to [OFF], then to [ON] again. Also, close the LCD monitor and retract the viewfinder and then

open the LCD monitor or extend the viewfinder again.

≥When using the AC adaptor, Quick Start can be used even if a tape/card is not inserted.

13

VQT0T29

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Operating Instructions Information for your safety VQT0T29 Contents Optional AccessoriesParts identification and handling CameraCard access lamp Reset button ResetSpeaker Audio-video/S-Video output terminal A/V LCD monitor -12Shoulder strap fixture Lens hood Tripod receptacleOne-touch free-style grip belt Fitting the lens cap VW-LF37WE optionalTo use as a grip belt To use as a hand strapPower supply How to turn off the power How to turn on the powerCharging time and recordable time Turning the camera onRecharging the built-in lithium battery Setting date and timeAbout date/time Using the viewfinder Using the LCD monitorAdjusting the field of view Adjust the focus by sliding the eyepiece corrector knob≥Set to Tape/Card Recording Mode To cancel Quick StartQuick Start Open the LCD monitor or extend the ViewfinderWhen the cassette holder cannot be housed When the cassette holder does not Come outInserting/removing a cassette Accidental erasure preventionInserting/removing a card Card access lampConcerning the card SD Memory CardHow to use the joystick Selecting a modeBasic joystick operations Joystick and screen displayCard recording mode AUTO/MANUAL/FOCUS switch is set to Auto Tape playback modeCard Playback Mode Switching the language Help modeUsing the menu screen To exit the Help modeOperating with remote control About the menu settingTo exit the menu screen To get back to the previous screenAdjusting the brightness and colour Level Adjusting LCD monitor/viewfinderOrder to increase the brightness Entire LCD monitor Changing the picture quality on LCD monitorRemote control Using the remote controlInstall a button-type battery Selecting the remote control mode Remote control usable rangeConcerning the button-type battery Connect the free style remote control To the camera Free style remote controlAbout the clip on the backside Recording mode About auto modeCheck before recording Basic camera holding≥Set to Tape Recording Mode On-screen display in the tape recording modeRecording on a tape Concerning the remaining tape time Indication on the screenBlank search function Recording checkStopping blank search midway Through ≥Set to Card Recording Mode On-screen display in the card recording modeRecording still pictures onto a card Photoshot To record still pictures clearlySelect the size of still pictures to be Recorded on a card Concerning the focusing areaSelect the picture quality for Photoshot images Recording with a shutter operation EffectDigital zoom function Zoom in/out functionAbout the variable speed zoom Function To use the zoom microphone functionBacklight compensation function Recording yourselfColour night view functions To return to normal recordingTele macro function Soft skin modeFade in/fade out function Anti-Ground-Shooting AGS Wind noise reduction functionWhen the video flash is not used Using the built-in video flashTo adjust the brightness of the video Flash Red eye reduction functionTo stop the timer midway through Self-timer recordingTo Cancel the Wide/43 Function Wide/43 Function≥Set to Tape/Card Recording Mode Set Advanced O.I.S. on To cancel the image stabilizer functionImage stabilizer function Continuous PhotoshotTo cancel the scene mode function Recording in various situations Scene modeRecording in natural colours White balance Manual shutter speed/aperture adjustment Manual focus adjustmentTo restore to automatic adjustment Manual iris/gain adjustment Manual shutter speed adjustmentShutter speed range Iris/gain value rangeSettings on the audio To adjust volumePlaying back tape Repeat playbackVariable-speed search function Slow-motion playback/ frame-by-frame playbackTo return to normal playback Playing back card Playback on TVTo display the on-screen information On the TV Move the joystick up to select Icon to start playbackTo display multiple playback files Deleting files recorded on a cardAbout the compatibility of still pictures To delete all filesFormatting a card To complete the settingsProtecting files on a card ≥In order to stop formatting, select noWhat is DPOF? Writing the printing data on a card Dpof settingSelect Cancel ALL in Step To set so that all pictures are not PrintedCopying onto a DVD recorder or a VCR Dubbing Recording from a tape onto a cardTo cancel the standby for recording Using the DV Cable for Recording Digital DubbingBefore recording with audio dubbing Audio dubbingTo play back the sound recorded with Audio dubbing You can add music or narration to the recorded cassetteWhen you stop printing halfway Tape Recording Menu Menu listTape Playback Menu Card Recording Menu Setup Display -52-REMOTECard Playback Menu Basic DATE/TIME -52-PROTECTMenus related to playback Menus related to taking picturesOther menus Demo ModeJoystick LED Initial SETBasic indications IndicationsRecording indications Playback indicationsTextual indications Confirmatory indicationsYou are attempting to erase protected files Functions cannot be used simultaneouslyThere is no ink. Check the connected printer There is no paper. Check the connected printerPower/Body Movie camera power cannot be turned on Before requesting repair Problems and solutionsMovie camera power is turned off automatically Movie camera power does not stay on long enoughCassette cannot be removed Remote control does not functionNo operation other than cassette removal can be performed Screen has changed suddenlyDifferent sounds are reproduced at the same time Original sound was erased when audio dubbing was performedAudio dubbing cannot be performed Sounds cannot be played backOthers Push the Reset Switch is displayedFrom Attempt to repair the appliance by yourselfAbout condensation When the lens is foggedAbout dirty heads Remove the tape if it is insertedBe sure to detach the battery after use About the batteryAbout the movie camera While carrying the movie camera, do not drop or bump itAbout the cassette About the AC adaptorAbout the card Folder structure of the card Explanation of termsPeriodical check-ups Automatic white balanceAuto focus White balanceSpecifications SpecificationsHttp//panasonic.co.jp/pavc/global/cs This Site is English onlyAC adaptor VSK0651 S1105Nw0 2500 a
Top Page Image Contents