Panasonic NV-GS180GN Install a button-type battery, Remote control usable range

Page 17

Before using

ªInstall a button-type battery

Install the button-type battery supplied in the remote control before using it.

1While pressing the stopper 1, pull out the battery holder.

1

2Set the button-type battery with its (i) mark facing upward and get the battery holder back in place.

Caution

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions.

Warning

Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 100 xC or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor.

ªRemote control usable range

The distance between the remote control and the camera: Within approx. 5 m

Angle: Approx. 10o up and 15o down, left, and right

ªSelecting the remote control mode

If 2 cameras are used simultaneously, set the mode for one pair of movie camera and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1 Setting on the camera:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2 Setting on the remote control:

2 1

[VCR1]:

Press [D] and [] simultaneously. 1 [VCR2]:

Press [E] and [] simultaneously. 2

ªConcerning the button-type battery

When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation

frequency.

Keep the button-type battery out of the reach of children.

If the remote control mode of the camera and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the camera is turned on, “CHECK REMOTE

MODE” (-47-) will appear and operation is impossible. Set the same remote control mode.

The remote control is intended for indoor operation. Outdoors or under strong light, the movie camera may not operate properly even within the usable ranges.

Within a 1 metre range, you can operate the remote control from beside the remote control sensor (LCD monitor side) of the movie camera.

17

VQT0T93

Image 17
Contents Operating Instructions Information for your safety Contents Accessories Before usingOptional Parts identification and handlingTripod receptacle Viewfinder -7Lens hood Fitting the lens capShoulder strap fixture Using the viewfinder Using the LCD monitorAdjusting the field of view Grip beltPower supply Inserting/removing a cassette Charging time and recordable timeSlide the OPEN/EJECT lever and open the cassette cover Push the Push mark 1 in order to close the cassette holderInserting/removing a card Turning the camera on Selecting a modeTape recording mode AUTO/MANUAL/FOCUS switch is set to Auto How to use the joystickCard recording mode AUTO/MANUAL/FOCUS switch is set to Auto Basic joystick operationsUsing the menu screen Switching the languageSet Language select the desired language For each individual menu, please refer toSetting date and time Adjusting the brightness and colour Level Adjusting LCD monitor/viewfinderOrder to increase the brightness Entire LCD monitor Changing the picture quality on LCD monitorRemote control Using the remote controlRemote control usable range Install a button-type batterySelecting the remote control mode Concerning the button-type batteryCheck before recording Record modeRecording on a tape On-screen display in the tape recording modeConcerning the remaining tape time Indication on the screen Remove the lens capBlank search function Check the recordingRecording still pictures onto a card Photoshot Stopping blank search midway ThroughConcerning the focusing area On-screen display in the card recording modeProgressive Photoshot Select the size of still pictures to be Recorded on a cardRecording yourself Zoom in/out functionDigital zoom function To use the zoom microphone functionQuick start To cancel the quick start when Power is set to OFFBacklight compensation function To return to normal recordingTo cancel the colour night view Function Soft skin modeTo cancel the soft skin mode Night view functionsTo cancel fading To cancel the tele-macro functionTele-macro function Fade in/fade out functionRecording images for wide-screen TVs Self-timer recordingWind noise reduction function ≥Set to Tape Recording Mode Set Advance SIS on To cancel the image stabilizer functionImage stabilizer function Continuous PhotoshotTo cancel the scene mode function Recording in various situations Scene modeRecording in natural colours White balance To restore to automatic adjustment Manual focus adjustmentManual shutter speed/aperture adjustment Iris/gain value range Manual iris/gain adjustmentShutter speed range Slow-motion playback/ frame-by-frame playback Playback modePlaying back tape Variable-speed search function Press the Play 1 button on the remote controlTo return to normal playback Frame-by-frame playbackTo display the on-screen information On the TV Playback on TVPlaying back card To display multiple playback files Deleting files recorded on a cardAbout the compatibility of still pictures To delete all filesFormatting a card To complete the settingsProtecting files on a card ≥In order to stop formatting, select noWhat is DPOF? Writing the printing data on a card Dpof settingSelect Cancel ALL in Step To set so that all pictures are not PrintedEdit mode Edit modeRecording from a tape onto a card Copying onto a DVD recorder or a VCR DubbingTo cancel the standby for recording Using the DV Cable for Recording Digital DubbingAudio dubbing ≥Set to Tape Playback ModeBefore recording with audio dubbing To play back the sound recorded with Audio dubbingWhen you stop printing halfway Menu list MenuTape Recording Menu Tape Playback MenuSetup Display -44-REMOTE SetupCard Recording Menu Picture Playback MenuMenus related to taking pictures Other menus Menus related to playbackIndications OthersTextual indications Confirmatory indicationsThere is no ink. Check the connected printer Functions cannot be used simultaneouslyThere is no paper. Check the connected printer Check the connected printerPower/Body Movie camera power cannot be turned on Before requesting repair Problems and solutionsMovie camera power is turned off automatically Movie camera power does not stay on long enoughCassette cannot be removed Remote control does not functionNo operation other than cassette removal can be performed Screen has changed suddenlyOriginal sound was erased when audio dubbing was performed HeadphonesPlayback Sound Different sounds are reproduced at the same timeUsing MotionDV Studio 5.3E LE for DV Push the Reset Switch is displayedDuring playback, Unplayable Card is displayed OthersAbout the movie camera About condensationAbout dirty heads Be sure to detach the battery after use About the batteryPrepare spare batteries when going out for recording While carrying the movie camera, do not drop or bump itAbout the cassette About the AC adaptorAbout the card Folder structure of the cardLCD monitor/viewfinder Explanation of termsPeriodical check-ups Automatic white balanceAuto focus White balanceSpecifications SpecificationsSpecifications Http//panasonic.co.jp/pavc/global/csPicture F1205Nm0 2500 a