Panasonic PV-GS180 Selecting the remote control mode, Concerning the button-type battery

Before using

ªSelecting the remote control mode

If 2 Camcorders are used simultaneously, set the mode for one pair of Camcorder and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1Setting on the Camcorder:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2Setting on the remote control:

2 1

[VCR1]:

Press [D] and [∫] simultaneously. 1 [VCR2]:

Press [E] and [∫] simultaneously. 2

ªConcerning the button-type battery

≥When the button-type battery (optional) runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency.

≥Keep the button-type battery out of the reach of children.

≥If the remote control mode of the Camcorder and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the Camcorder is turned on, “CHECK REMOTE

MODE” (-63-) will appear and operation is impossible. Set the same remote control mode.

≥The remote control is intended for indoor operation. Outdoors or under strong light, the Camcorder may not operate properly even within the usable ranges.

≥Within a 1 m (3 feet) range, you can operate the remote control using the remote control sensor on the LCD monitor side of the Camcorder.

25

LSQT0973