Panasonic PVGS90P About the battery, While carrying the Camcorder, do not drop or bump it

Page 47

Others

Do not spray insecticides or volatile chemicals onto the Camcorder.

If the Camcorder is sprayed with such

chemicals, the Camcorder body may become deformed and the surface finish may peel off.

Do not keep rubber or plastic products in contact with the Camcorder for a long time.

When you use your Camcorder in a sandy or dusty place such as on a beach, do not let sand or fine dust get into the body and terminals of the Camcorder. Also, protect the Camcorder from getting wet.

Sand or dust may damage the Camcorder or cassette. (Care should be taken when inserting and removing a cassette.)

If sea water splashes onto the Camcorder, wet a soft cloth with tap water, wring it well, and use it to wipe the Camcorder body carefully. Then,

wipe it again thoroughly with a soft dry cloth.

While carrying the Camcorder, do not drop or bump it.

A strong impact on the Camcorder may break its housing, causing it to malfunction.

Do not use benzine, paint thinner or alcohol for cleaning the Camcorder.

Before cleaning, detach the battery or pull out the AC Cable from the AC Jack.

The Camcorder body may be discolored and the surface finish may peel off.

Wipe the Camcorder with a soft dry cloth to remove dust and fingerprints. To remove stubborn stains, wring well a cloth that is soaked in a neutral detergent diluted with water and wipe the Camcorder with it. Afterwards, wipe it with a dry cloth.

When you use a chemical dust cloth, follow the instructions.

Do not use this Camcorder for surveillance purposes or other business use.

If you use the Camcorder for a long time, the internal temperature increases and, consequently, this may cause malfunction.

This Camcorder is not intended for business use.

When you are not going to use Camcorder for an extended time

When storing the unit in a cupboard or a cabinet, it is recommended that you put a desiccant (silica gel) in with it.

ªAbout the battery

The battery used in the Camcorder is a rechargeable lithium ion battery. This battery is susceptible to temperature and humidity, and the effect of temperature increases with increasing or decreasing temperature. In the low temperature range, the fully charged indication may not appear, or the low battery indication may appear about 5 minutes after the start of use. At high temperature, moreover, the protection function may work, disabling use of the Camcorder.

Be sure to detach the battery after use.

If the battery is left attached to the Camcorder, a minute amount of current is consumed even when the Camcorder power is OFF. If the battery is left attached to the Camcorder for a long time, over-discharge takes place. The battery may become unusable after it is charged.

The battery should be stored in a cool place free from humidity, with as constant temperature as possible. (Recommended temperature: 15 oC to

25 oC (59 oF to 77 oF), Recommended humidity: 40% to 60%)

Extremely high temperatures or low temperatures will shorten the life of the battery.

If the battery is kept in a high-temperature, high-

humidity, or oily-smoky places, the terminals may rust and cause malfunctions.

To store the battery for a long period of time, we recommend you charge it once every year and store it again after you have completely used up the charged capacity.

Dust and other matter attached to the battery terminals should be removed.

Prepare spare batteries when going out for recording.

Prepare batteries appropriate to 3 to 4 times the period you are planning to record for. Cold places such as a ski resort, can shorten the period during which you can record for.

If you drop the battery accidentally, check to see if the terminals are deformed.

Attaching a deformed battery to the Camcorder or AC adaptor may damage the Camcorder or AC adaptor.

Do not throw old battery into fire.

Heating a battery or throwing it into a fire may result in an explosion.

If the operating time is very short even after the battery has been recharged, the battery has worn out. Please purchase a new battery.

47

LSQT1284

Image 47 Contents
Model No. PV-GS90P/PC Do not Expose this Equipment to Rain or Moisture Following mark and symbols are located on bottom of the unitFollowing Applies only in Canada Following Applies only in the U.S.ADeclaration of Conformity Trade Name Panasonic Model No PV-GS90PImportant Safety Instructions Care Battery pack Lithium ion battery packUSE & Location AC adaptor Contents Quick Guide AccessoriesCharging the battery Inserting the batteryPlaying back tape How to turn on the powerRecording on a tape Viewfinder -16 Parts identification and handlingCamcorder LCD monitor -16 How to remove the Sensor tag for U.S.A. onlyCharging lamp Charge Using the lens coverPower supply Grip beltCharging time and recordable time Connecting to the AC outletRemoving the battery Tape Playback Mode Selecting a mode Turning the Camcorder on/off≥Rotate the mode dial slowly Tape Recording ModeAbout date/time Setting date and timeRecharging the built-in lithium battery Adjust the focus by sliding the eyepiece corrector knob Using the LCD monitorUsing the viewfinder Adjusting the viewfinder field of viewOpen the LCD monitor or extend the Viewfinder To cancel Quick StartSet Setup Quick Start OFF Quick StartAccidental erasure prevention When the cassette holder does not come outWhen the cassette holder cannot be housed Inserting/removing a cassetteJoystick and screen display How to use the joystickTape playback mode Basic joystick operationsLanguage selection Help modeUsing the menu screen To exit the Help modeTo exit the menu screen Adjusting LCD monitor/viewfinderAbout the menu setting Adjusting the brightness and color levelPress the Light button To cancel the built-in LED video lightRecording with the built-in LED video light Basic Camcorder positioning About auto modeRecording mode Check before recordingAbout the remaining tape time indication on the screen On-screen display in the tape recording modePower Save Recording on a tapeStopping blank search midway through Recording checkBlank search function Continuous photoshot ≥Set to Tape Recording ModeRecording a still picture on a tape Photoshot Zoom in/out functionBacklight compensation function Recording yourselfMagicPix function Soft skin modeTo cancel the MagicPix function To cancel the soft skin modeWind noise reduction function To cancel fadingTo cancel the wind noise reduction function Fade in/fade out functionGuideline function Aspect ratioOptical image stabilizer function ≥Set to Tape Recording Mode Set Advanced Auto SLW Shtr on Auto slow shutter modeTo cancel the slow shutter mode To cancel the scene mode function Recording in various situations Scene modeRecording in natural colors White balance Manual focus adjustmentIris/gain value range Manual shutter speed/aperture adjustmentTo restore to automatic adjustment Shutter speed rangeRepeat playback To adjust the speaker volume during playbackSettings on the audio Playing back tapeTo return to normal playback Frame-by-frame playbackPlayback on TV Copying onto a DVD recorder or a VCR Dubbing Edit modeStop playback. Player Using the DV Interface Cable for Recording Digital DubbingTo cancel the standby for recording CPU Using on MacintoshPC Connection with the DV Interface Cable Operating environment on iMovie HDAdvanced REC Speed REC Stdby -38-REPEAT Play Menu listTape Recording Menu Tape Playback MenuOther menus Menus related to recordingMenus related to playback Indications Wrong Tape Format Functions that cannot be used simultaneouslyBefore requesting repair Problems and solutions Different sounds are reproduced at the same time Push the Reset Switch is displayedRemaining tape time indication disappears Indication are not shownAbout the Camcorder About condensationAbout dirty heads Do not throw old battery into fire About the batteryBe sure to detach the battery after use Prepare spare batteries when going out for recordingPeriodical check-ups About the AC adaptorAbout the cassette LCD monitor/viewfinderAuto focus White balance adjustmentExplanation of terms Automatic white balanceImage sensor SpecificationsAccessory No Description Camcorder Accessory SystemVisa Camcorder Accessory Order Form For USA CustomersRequest for Service Notice USA Only Request for Service NoticePanasonic Video Products Limited Warranty For USA CustomersNpcparts@us.panasonic.com Customer Services DirectoryAccessory Purchases Centralized Factory Service CenterLimitations and Exclusions Warranty ServiceIf YOU Ship the Product to a Servicentre Numerics IndexSpanish Quick Use Guide Guía española para el uso rápido Reproducción de la cinta Panasonic Puerto Rico, Inc