Panasonic PV-L453 AccuBrite Built-in Light, Using the Light, Replacing the Bulb

Page 16

AccuBrite™ Built-in Light

Using the Light

Before you begin...

For recording in dim lighting.

•Connect Camcorder to power source.

•Set POWER to CAMERA.

1, 2

3

Note:

•Using Light reduces battery operating time.

•Provide proper ventilation when using Light extensively in a hot environment.

•Using Light when the Camcorder is powered by a car battery may shorten bulb life.

•Set Light to OFF when not in use.

•When Camcorder is in CAMERA or PHOTO Rec mode with LIGHT MODE set to ON or AUTO, changing to VCR or PHOTO Play mode will cause the light to go out and the menu setting will revert to OFF.

When returning to CAMERA or PHOTO Rec mode, the LIGHT MODE must be set again.

1 Press MENU for MENU mode. Press UP or DOWN to

select LIGHT MODE .

2Press M.FOCUS to set OFF/ON or OFF/ON/AUTO. Press MENU to exit.

3Press LIGHT repeatedly for Light ON, AUTO, or OFF.

•In AUTO, light turns itself on/off according to lighting conditions.

EVF or LCD Monitor

: Light is on.

A : Light mode is auto.

CAUTION:

mark is indicated that light becomes hot. Never cover Light while on.

Replacing the Bulb

B

1

A

2

3

Before you begin...

•Order Part No. VLLW0015 for replacement bulb.

•Set POWER to OFF.

1 Slightly raise portion A of lens cover to unhook, and slide portion B forward to remove.

2Using Tweezers or needle-nose pliers, carefully remove bulb.

•Take unit to service center if you need assistance.

3Replace bulb using a clean cloth or tissue. (Do not touch with fingers.)

4Replace lens cover.

Note:

•Handle bulb gently. Excessive force may cause bulb to crack.

DANGER:

Use only replacement bulb (PART NO. VLLW0015) supplied by Panasonic to reduce risk of fire. Handle new bulb with cloth or tissue as skin oils will decrease bulb life.

Remove lens cover and allow bulb to cool before replacing to avoid possible burn hazard.

16

For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com

Image 16

Contents Operating Instructions Guía para rápida consulta en español está incluidaUnpack your Camcorder Things You Should KnowThank you for choosing Panasonic Above markings are located on the appliance’s bottom cover Safety PrecautionsPV-L453 Important Safeguards Precautions If the video unit has been exposed to rain or waterTable of Contents Self Demo Mode Self DemoCharging the Battery Pack Playback using the LCD MonitorQuick Operation Guide Insert CassetteUsing the Battery Pack Supplying PowerBattery Refresh Car Battery Cord Optional Battery CareAC Adaptor Cassette Information Cassette Insertion/RemovalRecord/Playback Time Erase Protection TabBefore Using Using Menu Mode Camera Mode Menu Screen VCR Mode Menu ScreenCamera Mode VCR Mode Setting the ClockPress Menu twice to exit 3a Setting the Time Zone 3c Setting Date and TimeTime Zone chart 3b Auto Daylight Saving TimeUsing the Light AccuBrite Built-in LightReplacing the Bulb Press Menu for Menu mode. Press UP or Down toTo adjust LCD Bright Camera RecordingRecording via EVF or LCD Monitor CameraStand-by Quick Release Manual Easy EditingEasy Edit Stand-by STAND-BY ReleaseProgrammed Recording REC TimeProgrammed REC REC TimePlayback on EVF or LCD Monitor Playing Back RecordingsSpecial Effects Tracking Control VCR Playback using PlayPak Optional TV Playback or ViewingCopying your Tapes dubbing ConnectionsMonitor with your TV Before you beginFour-Speed Power Zoom BacklightZoom In T Zoom Out W Zoom slowly Zoom quicklyPress Menu for Menu mode Press UP or Down to select MagicPix ImagesDigital Effects Press M.FOCUS forFocus Auto FocusManual Focus Macro Focus close-upsHigh Speed Shutter Auto ShutterManual Selection Press M.FOCUS repeatedly to selectAuto Fade FadeBlack Fade Out FADE/FILTERColor Digital Fade Press Menu for Menu mode. Press UP or Down to select Digital FilterPress Menu twice to exit Press T on Power Zoom Repeat steps 2~3 to select OFF to cancel this featureDigital Zoom Press M.FOCUS repeatedly to select D.ZOOM1, D.ZOOM2, or OFFNormal Digital EIS onStill/ Strobe/ Wide NormalWideMotionSensor MotionSensor may mistakenly start whenMotionSensor may not start when MotionsensorSD Memory Card write protection switch Digital Still CameraMemory Card* optional Insertion/ RemovalRecording PhotoPress UP or Down Press RECORD/PAUSE to captureSet Light to Auto PlaybackPress Play Displayed Directory/Image Number DCF NumberDelete Specific Images Deleting Specific Image PagesDeleting All Image Pages Format the Memory CardPicture in Picture Wipe Title Press Mode repeatedly for Wipe effect 1, 2, or 3 See left Digital Wipe ModePress Start Software Installation Windows 95/98/Me/2000/XP PC ConnectionDigital PhotoShot Software System Requirements for Digital PhotoShotUsing Live Image Data Running the Software Windows 95/98/Me/2000/XPUsing Memory Card Image Data Using PC Image DataDriver Quick Reference Using a SD Pcmcia Adaptor optional Inserting a Memory Card optionalViewfinder/LCD Monitor Indications Mode SelectFull Empty Display-Off Mode Set Power to Camera or VCRRecording the Date and Time Display SETVCR-MODE CAMERA/VCR modePause Photo mode ForA. Consumers Attention Clock Battery Replacing Clock BatteryInsert Battery Tray so the triangle marks meet Palmcorder Accessory System Palmcorder Accessory Order Form VisaSpecifications Video Head Cleaning Before Requesting ServiceSymptom Correction Request for Service Notice Self Diagnostic SystemLimited Warranty Panasonic/Quasar Video Products Limited WarrantyCustomer Services Directory Centralized Factory ServicenterSpanish Quick Use Guide/Guía Para Uso Rápido Symbols Index