Setup 1 Charging
Insert the battery into the unit and charge it.
1 Set the mode dial to [OFF].
The unit runs on AC power (status indicator lit red) and the battery cannot be charged when the mode dial is set to any position other than [OFF].
2 Opendoor. the card/battery
Slide the lock to the OPEN side and lift the projection with a finger to open.
OPEN
Projection
3 Insert the battery.
Ensure that battery is oriented correctly, and push it into the compartment in the direction of the [▲] until it snaps into place and it is locked by the lever.
(To remove the battery, press the lever downward.)
4 Closedoor. the card/battery
Press [ ] until hearing the door snap closed.
5 Connect the AC adaptor (supplied).
Connect the AC cable to the AC adaptor and then to an AC outlet.
To AC outlet
Lever | Press here. |
| |
| OPEN |
Check that the red marker of the lock is no longer visible.
AC adaptor
AC cable*
Small gap here.
*Do not use the AC cable and AC adaptor of this unit with other devices. Also, do not use the AC cables and AC adaptors of other devices with this unit.
22 VQT1M21