Panasonic SDR-SW20P Disc cannot be used or cannot be written on. Use, New disc

Page 89

This section explains the main messages appearing on the LCD monitor and how to deal with them.

Message

PLEASE CONNECT AC ADAPTOR

ERROR OCCURRED. PLEASE TURN UNIT OFF, THEN TURN ON AGAIN.

What to check

You tried connecting the unit to a computer without connecting the AC adaptor.

The unit detected an error. Eject the SD card and shut power off and turn back on.

DISCONNECT USB CABLE.

CANNOT OPERATE WHILE CONNECTED TO COMPUTER.

CARD ERROR DETECTED.

NOW REPAIRING DATA.

The unit is not properly connected to a computer or printer.

Disconnect and reconnect the USB cable.

Power to the unit cannot be shut off while it is connected to a computer.

The data on the SD card contains errors.

To repair the data, either use a battery of sufficient life or connect the AC adaptor. Depending on the error, it may take time to repair the data.

The data has been repaired.

●Depending on the situation, the data may not be completely repaired.

●If power is shut off without repairing data, data can be repaired the next time that power is turned on.

●If repairing fails, the data cannot be played back. Format the SD card with this unit.

●Do not repair SD cards recorded on other devices on this unit.

DISC IS UNUSABLE.	The disc cannot be used or cannot be written on. Use
CHECK DISC.	a new disc.
CANNOT CHECK
CONNECTED	A device that cannot be used with this unit is
DEVICE.	A device that cannot be used with this unit is
DISCONNECT THE	connected to the unit.
USB CABLE FROM
THIS UNIT.

VQT1M21 89

Image 89

Contents VQT1M21 Model No. SDR-SW20P/PCThank you for choosing Panasonic Things You Should KnowSDR-SW20P Following Applies only in the U.S.AImportant Safety Instructions AC adaptor BatteryBattery pack Lithium ion battery pack Camera and SD card sold separately temperature PrecautionsFor the purposes of these operating instructions Indemnity concerning recording contentLCD monitor Carefully observe copyright lawsWater resistance Important Water resistanceUnderwater use Care after underwater useHandling Card/Battery door and terminal coverReplacing the water-resistant packing Lens, microphone and speakerContents Accessory Order Form Optional accessoriesRequest for Service Notice USA Only Limited WarrantyInsert the battery Set the mode dial to OFF Opendoor. the card/batteryClosedoor. the card/battery Quick guideEnter the date and time Open the terminal coverPlug the DC plug into DC input terminal on the unit Set to Start recording Take picture Stop recording RecordingDuring playback Set to Select and enter the picture to viewParts identification AccessoriesTripod mounting hole CD-ROMHandling Mode dial P.26Using as strap Using the 2-way hand strap suppliedUsing as a grip belt Parts identification and handlingUsing the LCD monitor SD Memory Card SD/SDHC Memory Card Recommended Panasonic SD/SDHC Memory Cards as of DecemberType of card Capacity Write-protecting cards Precautions in handlingSet the mode dial to OFF Setup 1 ChargingTo AC outlet Lever Press here AC adaptor AC cable＊Does not flash If the status indicator does the followingRemaining battery capacity indication SetupCharging time and recordable time Charging time Approx hours 15 minutesInsert/Removecard. the SD Setup 3 Inserting/Removing SDSet to icon of desired mode Setup 4 Turning power ON/OFF Selecting modesTurning power ON/OFF from the LCD monitor When not in use, set the mode dial to OFFSetting Quick Start Make settings from the menus. P.28Indicator Quick startsDisplay the menu Setup 5 Setting from the menuSelect the top menu To return to the previous screenSelect an item Enter the selected item Close the menu Using the cursor buttonsSet to or Select the desired menu Setting the date and timeTo change the date and time display FormatAdjusting the LCD monitor Adjusting the LCD monitorSelectitem. and adjust Changing the display languageBasic stance Recording 1 Before recordingTaking pictures underwater Hold the unit firmly with both handsAutomatic recording motion/still pictures Card/battery doorPress Start recording Recording 2 Automatic recording motion picturesSet to If recording stops Recording mode and recording timesTo change recording mode Set to Press Take picture Recording 3 Automatic recording still picturesTo remove shutter sound →ADVANCED→SHTR EFFECT→OFFTo avoid jitter Picture qualityTo change picture quality Recording 4 Zoom/avoid jitter/maintain Enlarge RestoreEnlarging zoom To enlarge furtherAvoid jitter image stabilizer function Picture brightness in dark locationsApply zoom effect to sounds zoom microphone →ADVANCED→ZOOM MIC→ONChange operation icons Recording 5 Other recording optionsDisplay operation icons →ADVANCED→FADE COLOR→WHITE / Black Fade-in/Fade-outRecording 5 Othercont. recording options Self-timerBacklight compensation function To quit halfway throughMagicPix function Soft skin modeRecording 6 Recording manually motion/still pictures Adjusting focus manually manual focus adjustmentSet to or To return to automatic recordingTo cancel the setting Using situation-specific settings scene modeAchieve natural colors white balance Setting manuallyAuto white balance range To return to automatic adjustment Set to or ＊Shutter speed adjustment range Adjusting shutter speed shutter speedTo return to automatic adjustment Iris/gain value adjustment range Adjusting brightness iris/gainSetting the city and region of your travel destination Setting home city and regionTo cancel Recording 7 Useful functions→BASIC→GUIDE LINES→ON Restoring local date and time after returning homeAvoid wind noise wind noise reduction function Playback 1 Viewing motion pictures To adjust the volumeSelect the desired scene Enter the picture to viewSelect the date to display Displaying thumbnails by dateFast forward/rewind playback PlaybackSlow-motion playback Frame-by-frame playbackSet to Enter the picture to view Playback 2 Viewing still picturesEditing 1 Deletingpictures motion/still To cancel deletion halfway throughSet to or Deleting one picture at a timeSelecting and deleting multiple pictures Deleted pictures cannot be restoredDeleting all pictures Preventing accidental deletion →SETUP→FORMAT CARD→YESFormatting cards →EDIT SceneDpof SET→CANCEL ALL Setting Dpof for still→PICT. SETUP→DPOF SET→SET PicturesWith other 1 Playback on TV →SETUP→EXT. DISPLAY→ONProducts To display LCD monitor information on TVCopying to video recorders Copying pictures using the AV cable suppliedOr DVD recorders With otherPictBridge printers Printing pictures fromTo cancel printing Print settingsAvailable settings PRINT→YESRequired equipment as of December Using DVD burnersSupported discs 12 cm disc Time required for copying ReferenceConnecting this unit and a DVD burner Copying all motion pictures to discs To cancel copyingCopying still pictures to discs Select Scenes Select Date Copying selected motion pictures to discsCopying using a DVD burner Exiting Playing back discsDeleting copied motion pictures →EDIT SCENE→DELETE →COPIED →YESComputer Software on the CD-ROMWith a Video editing software MotionSD Studio 1.3EEnd User License Agreement End User LicenseAgreement Operating environment required for MotionSD Studio Operating environmentMicrosoft Windows XP Home Edition/Professional Studio Installing MotionSDUninstalling the software If the Setup Menu does not start up automaticallyImporting motion pictures and still pictures Using MotionSD StudioClosing MotionSD Studio Editing motion pictures and still picturesClick in the lower right- hand corner of the screen From the SD Browser screenConnecting the unit to a computer Using this unit as anDisconnecting the unit External drive Mass storageSD card folder structure Checking the connections When the driver is recognizedWhen the driver is not recognized Connecting the unit to a the computer Connecting to a MacintoshComputer Operating environment required for external drivesRecording menu Others 1 MenusPlayback menu Top menu Submenus PurposeSettings/Notices Mode Purpose Setup menuDate YES / no OFF Settings/Notices ModeOthers 2 LCD monitor displays When recordingMotion picture recording display Still picture recording displayStill picture playback display During playbackMotion picture playback display Message Others 3 MessagesNew disc Disc cannot be used or cannot be written on. UseDevice that cannot be used with this unit is Connected to the unitPower does not turn on Others 4 TroubleshootingStatus indicator is flashing while using the battery Unit does not operate normallyMotion picture recording stops on its own Data cannot be deleted Speaker volume is lowUnit does not recognize the SD card when inserted An error message After disconnectingIndication Disappears,Error Image stabilizer Mode While using MagicPix Scene mode Fade ModeFunction cannot be used or selected Function Condition Digital zoomOthers 5 Cautions for use When using the unitSD cards BatteryLCD monitor AC adaptorShock proof CleaningCondensation Others 6 Specifications Power source Recording mode and transferPower consumption Recording mediaOthers Optional accessoriesAccessory No Description Visa Accessory Order Form For USA CustomersFailure to do so will delay your repair Request for Service Notice USA OnlyFor hearing or speech impaired TTY users, TTY Customer Services Directory For USA onlyLimited Warranty Coverage Panasonic Video Products Limited WarrantyLimited Warranty Limits And Exclusions Carry-In, Mail-in Prepaid or In-Home ServiceWarranty For Canadian Customers Numerics IndexInserte la batería Spanish Quick Use Guide/Guía españolaCierre la tapa de la tarjeta/batería Conecte el adaptador de CA suministradoIntroduzcahora. la fecha y la Para el uso rápidoAbra la cubierta del terminal Imágenes en movimiento GrabaciónPóngalo en Imágenes en movimientoDurante la reproducción Seleccione SÍ Deseada.Seleccione la escena114 VQT1M21 VQT1M21 Panasonic Canada Inc Panasonic Puerto Rico, Inc