Panasonic AG-HPX170 manual 110, Other Functions screen

Setup menu list (continued)

CARD FUNCTIONS screen (continued)

Item	Display	Description of settings
	mode
SD CARD FORMAT	(Camera)	Formats the SD memory cards.

OTHER FUNCTIONS screen

Item	Display	Description of settings
	mode
USER FILE	(Camera)	LOAD:
	(MCR)	Loads the settings in a previously stored user file.
		SAVE:
		Saves the updated user file settings.
		INITIAL:
		Returns the user settings in the user file to the factory settings.
		After a LOAD or INITIAL operation, turn the POWER switch off and
		then back on again to make the new settings available.
		• An INITIAL operation does not change the TIME ZONE settings
		(Page 111).
REMOTE	(Camera)	Sets the operations of the supplied remote control unit. (Remote control
	(MCR)	setup. (Page 18))
		OFF:
		Operations are not accepted from any remote control.
		1:
		Accepts commands from the remote control set for “operation mode 1”.
		2:
		Accepts commands from the remote control set for “operation mode 2”.
1394 CONTROL	(Camera)	Sets the control method for backup recording using a backup unit
		connected to the 1394 terminal.
		OFF:
		The backup unit is not controlled.
		EXT:
		The backup unit can be controlled by the START/STOP button. The
		images shot by the camera recorder are recorded by the backup unit.
		Note that the camera recorder does not record them.
		BOTH:
		The images shot by the camera recorder are recorded by both the
		camera recorder and backup unit.
		CHAIN:
		When the camera recorder’s media approaches its end during
		shooting, the backup unit in the recording stand-by mode automatically
		starts recording images.
1394 CMD SEL	(Camera)	Sets how the START/STOP button works for the backup unit.
		REC_P:
		This switches between recording and pause.
		STOP:
		This switches between recording and stop.
		<Note>
		If the backup unit does not have a rec pause function, select STOP.
PC MODE	(Camera)	Selects the terminal for data transfer. (You cannot select USB and 1394
	(MCR)	at the same time.)
		USB DEVICE:
		Mode for sending files using the USB connector.
		1394 DEVICE:
		Mode for sending files using the 1394 connector.
		1394 HOST:
		Mode for copying files from the P2 card onto an external hard disk drive
		using the 1394 connector.

110 ___indicates the factory setting.