Panasonic BT-LT80W manual VF Config

Main Menu (continued)

VF CONFIG

		The underlined values are factory preset setting values.
Sub menu	Settings	Explanation
VF CONTROL	VF-CH	Used to select the input line for the VF function of the monitor.
	ALL-CH	(VF function: tally lamp lit, zebra displayed, displayed)
		<VF-CH> Only enabled when the VF line is selected.
		<ALL-CH> Enabled with all input lines.
CROSS HATCH	HIGH	Used to set whether to display a cross hatch and select its density
	LOW	level.
	OFF	<HIGH> 70/256 (displays with a dense cross hatch)
		<LOW> 20/256 (displays with a light cross hatch)
		<OFF> Not displayed.
REAR TALLY	ON	Used to allow control of the tally lamp on the rear of the monitor.
	OFF	<ON> Lamp lights when TALLY control from a GPI/camera is ON.
		<OFF> Lamp does not light.
ZEBRA	ON	Used to set ZEBRA information in the camera.
	OFF	<ON> Sets the information to ON.
		<OFF> Sets the information to OFF.
RETURN CH∗1∗2	YPBPR	Used to select the signal input line by operating the RETURN (RET)
	VF	button of the camera lens.
	VIDEO	<Note>
	SDI	When there is no SDI input unit (option), the SDI item is displayed in
		gray and cannot be set.

• The priority sequence for GPI control and RS-232C is as follows: GPI > VF CONFIG > RS-232C.

∗1 RETURN CH operates when VF CONTROL is set to ALL-CH. It is not affected by the various line ON/OFF settings in the INPUT SELECT menu (→ page 29). (Input lines that are set with RETURN CH are enabled even if they are set to OFF in INPUT SELECT.)

∗2 A function to be used with future Panasonic camera-recorders.

22