Panasonic BT-LT80W manual Function, FUNCTION1, DISPLAY∗8

Main Menu (continued)

FUNCTION

		The underlined values are factory preset setting values.
Sub menu	Settings	Explanation
FUNCTION1 - 3	BLUE ONLY	Used to select the functions to be assigned to individual buttons
	SD ASPECT∗1∗2	[FUNCTION1] to [FUNCTION3] (front-panel buttons).
	WFM	<BLUE ONLY>
	MARKER∗1∗3	Used to cut the red and green signals. You can check the hue (PHASE)
	PIXEL TO PIXEL∗4	and depth of color (CHROMA). This is switched between ON/OFF by
	PIXEL POS.+∗5	pushing the button.
	PIXEL POS.–∗5	<SD ASPECT>
	FOCUS-IN-RED	Used to switch between “16:9” and “4:3”.
	∗4∗7	<WFM>
	ZEBRA	Used to display the waveform display screen.
	REAR TALLY∗6	<MARKER>
	CROSS HATCH	Used to display the marker.
	MONO∗1	<PIXEL TO PIXEL>
	UNDEF	Used to switch the screen display between input size and display
		size.
	(Factory preset	<PIXEL POS.+>
	setting→	During PIXEL TO PIXEL display, used to move the signal display
	FUNCTION1:	position clockwise and display it.
	WFM	<PIXEL POS.–>
	FUNCTION2:	During PIXEL TO PIXEL display, used to move the signal display
	PIXEL TO PIXEL	position counterclockwise and display it.
	FUNCTION3:	<FOCUS-IN-RED>
	FOCUS-IN-RED)	Used to highlight in red the section of the image that is being
		focused.
		<ZEBRA>
		Used to set the zebra display ON or OFF for the camera.
		<REAR TALLY>
		Used to set the rear tally ON or OFF.
		<CROSS HATCH>
		Used to display a cross hatch.
		<MONO>
		Used to switch the display between color and black-and-white.
		<UNDEF>
		Undefined.
FUNCTION	ON1	Used to display the functions assigned from [FUNCTION1] to
DISPLAY∗8	ON2∗9	[FUNCTION3] (buttons on the front panel). The button action can also
	OFF	be selected (1-touch, 2-touch, OFF).
		<ON1>
		Function display and function operation can be performed with one
		touch.
		<ON2>
		Function display and function operation can be performed with two
		touches.
		<OFF>
		Function not displayed.

• If a FUNCTION button is pushed during the picture adjusting knobs display, the picture adjusting knobs display will be cancelled and the FUNCTION operation cannot be executed.

∗1 The control settings do not operate during GPI operation.

∗2 If these settings are changed, the menu settings will also change.

∗3 Not displayed when 16:9, 4:3, BACK and CENTER are all OFF in the MARKER menu settings. ∗4 SD ASPECT cannot be switched when PIXEL TO PIXEL is ON during SD display.

∗5 PIXEL POSITION is not backed up. It is always CENTER when the power supply is switched ON. ∗6 Only enabled when TALLY control from the camera is ON.

∗7 During FOCUS-IN-RED operation, the detection sensitivity can be changed with the FOCUS-R knob. The setting range is from 0 to 30, with 30 the most sensitive detection.

∗8 The operating status is displayed regardless of the ON/OFF setting.

∗9 The function displayed with the ON2 setting can be operated with a button only during the time that it is displayed.

23