Major operating controls and their functions

Interface bracket

ENGLISH

EVF connector 1 [EVF1]

The viewfinder (WV-VF65B, AW-VF80) is connected here.

5EVF connector 2 [EVF2]

7Inter-communications level control [LEVEL]

This adjusts the sound level output to the inter-communications headset.

The viewfinder AW-VF64 is connected				8 Inter-communications jack (M3)
here.				[INCOM]
				The inter-communications headset is
	Note
				connected here.
 Do not connect EVFs to EVF
		connectors 1 and 2 (4 and 5) at		If the plug diameter does not match, use
				the adjuster plug (M6  M3) supplied
		the same time.
				with this product.

6 EVF standby / VIDEO ON/OFF				MIC:	Dynamic (With Preamp)
					50 /–20 dB
switch				Receiver: 150  (max. 200 mW)
[ST.BY / VIDEO ON/OFF]				9 EVF I/F cable
<For the WV-VF65B, AW-VF80>
				This is connected to the EVF I/F
ST.BY: Places the viewfinder in standby
				connector 1 on the SDI card.
		mode.

ON:		Outputs images to the viewfinder.		 TALLY input connector [TALLY IN]
<For the AW-VF64>				This is the tally control external input
VIDEO ON: Outputs images to the				connector.
			viewfinder.	OPEN:	TALLY OFF
VIDEO OFF: No images appear on the				SHORT: TALLY ON
			viewfinder.	When using the AW-CB400 remote
The AW-VF64 does not come with a				operation panel and AW-CA50T8G
standby function.				control cable for connecting to the
				convertible camera, connect the TALLY
				cable of the AW-CA50T8G to this
				connector.
		-		(E) -