
Major operating controls and their functions
SDI card
EVF I/F connector [EVF I/F]
The EVF I/F cable 9 from the interface bracket is connected here.
SDI output 1, 2 connector [SDI OUT 1, 2]
SDI signals are output from here.
Setting switches
| SW NO | OFF | ON |
1 | EDH | ENABLE | DISABLE |
2 | SETTING | E350 | E860 |
3 | DATA CLIP | NORMAL | CLIP |
4 | NTSC/PAL | NTSC | PAL |
1:EDH <ENABLE/DISABLE> (Factory setting: ENABLE)
An EDH flag is added to SDI output at the ENABLE setting.
2:Model selection <E350/E860> (Factory setting: E350)
When the
When the
3:DATA CLIP <NORMAL/CLIP> (Factory setting: NORMAL)
At the NORMAL setting, signal input is output at the same level at which it was input.
At the CLIP setting, signal input at less than 0% is output at 0%, and signal input at more than 100% is clipped at 100%.
4:NTSC/PAL switching <NTSC/PAL> (Factory setting: NTSC)
Leave this switch at the factory setting.
- (E) -