Cisco Systems UCS C210 manual Dvd+Rw, Dvd-R, Dvd-Rom, Dvd-Rw, +R Dl

Page 17

Chapter

 

 

Table 1-1

Hardware Features of the Server (Continued)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Feature or

 

 

 

 

 

 

 

 

 

 

 

Component

 

Cisco UCS C210 Server

 

 

 

 

 

 

 

 

 

Disk

 

Factory-configured RAID5 support options:

 

 

 

Management

 

RAID 0 and 1 support for up to five SATA drives with the integrated SATA

 

 

 

 

 

 

 

 

 

 

 

controller.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Note The integrated ICH10R RAID controller is not compatible for use with

 

 

 

 

 

 

 

 

VMWare ESX/ESXi Server software in any generation or version of

 

 

 

 

 

 

 

 

the Cisco UCS C210 server.

 

 

 

 

 

 

 

 

 

 

 

 

 

RAID 0, 1, and 1E support for up to four SAS or SATA drives with the optional

 

 

 

 

 

 

LSI 1064-based controller mezzanine card.

 

 

 

 

 

RAID 0, 1, 5, 6, 00, 10, 50 and 60 support for up to 16 SAS or SATA drives

 

 

 

 

 

 

with the optional LSI 9261-8i MegaRAID controller card.

 

 

 

 

 

RAID 0, 1, 5, 6, 00, 10, 50 and 60 support for up to 4 SAS or SATA drives with

 

 

 

 

 

 

the optional LSI 9280-4i4e MegaRAID card.

 

 

 

 

 

See Appendix C, “RAID Controller Considerations” for more information about

 

 

 

 

 

RAID in this server.

 

 

 

 

 

 

 

 

 

PCIe I/O

 

Up to five standard-profile PCIe6 expansion cards (or low-profile cards with a

 

 

 

 

 

standard-profile adapters), plugged into horizontal riser card sockets.

 

 

 

 

 

Two of the riser card sockets are full-length, x8-lane, with a x16 connector. The

 

 

 

 

 

other three riser cards are half-length, x8-lane, with a x16 connector.

 

 

 

 

 

 

 

 

 

Network and

 

The server provides these rear-panel connectors:

 

 

 

management I/O

Two 10/100/1000 Gigabit Ethernet ports (RJ-45 connectors).

 

 

 

 

 

 

 

 

 

 

 

These integrated Gigabit ports support the Wake on LAN (WoL) and TCP/IP

 

 

 

 

 

 

Offload Engine (TOE) standards.

 

 

 

 

 

One 10/100 Ethernet management port (RJ-45 connector).

 

 

 

 

 

One DB9 serial connector.

 

 

 

 

 

One 15-pin VGA7 connector.

 

 

 

 

 

Two USB8 2.0 connectors.

 

 

 

 

 

The server also has one front-panel console connector (with supplied KVM9 cable

 

 

 

 

 

provides DB15 video, DB9 serial, and two USB 2.0 connectors).

 

 

 

 

 

 

 

 

Removable media

One internal DVD drive (orderable option).

 

 

 

devices

 

The drive supports the following media types: CD-R, CD-ROM, CD-RW, DVD+R,

 

 

 

 

 

 

 

 

 

 

DVD+RW, DVD-R, DVD-ROM, DVD-RW, +R DL

 

 

 

 

 

 

 

 

 

Power

 

Up to two power supplies, each with a maximum output of 650 W.

 

 

 

 

 

 

 

 

 

Cooling

 

Three internal fans that force front-to-rear cooling; also one fan in each power

 

 

 

 

 

supply.

 

 

 

 

 

 

 

 

 

Video

 

The server CIMC chip includes a Matrox G200 core. The Matrox G200 core shares

 

 

 

 

 

the same memory as the rest of the CIMC. The first 8 MB of memory are allocated

 

 

 

 

 

to the video core, followed by another 5 MB allocated to the compression engine

 

 

 

 

 

for difference buffers.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Cisco UCS C210 Server Installation and Service Guide

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OL-20887-02

 

 

 

 

 

 

1-3

 

 

 

 

 

 

 

 

 

 

Image 17
Contents Americas Headquarters Covers UCS C210 Server Generations M1 and M2Page N T E N T S Replacing a SAS Extender or SAS Expander Card KVM Cable B-1 OL-20887-02 Audience Related DocumentationOrganization Chapter Title DescriptionBewaar Deze Instructies ConventionsAvvertenza Importanti Istruzioni Sulla Sicurezza Warnung Wichtige SicherheitshinweiseGuarde Estas Instruções Aviso Instruções Importantes DE SegurançaGEM Disse Anvisninger Xii Obtaining Documentation and Submitting a Service Request Xiv Overview Feature or Component Cisco UCS C210 Server DVD+RW, DVD-R, DVD-ROM, DVD-RW, +R DL Chapter Installing the Server Unpacking and Inspecting the Server Shipping Box ContentsInstallation Guidelines Preparing for InstallationRequired Equipment Slide Rail Adjustment RangeRack Requirements Installing the Server Into a Rack Attaching a Slide-Rail Assembly Attaching Mounting Brackets to the Server Attaching the Cable Management Arm Connecting and Powering On the Server Standalone Mode Initial Server SetupOL-20887-02 Cisco UCS C210 Server Installation and Service Guide NIC Modes and NIC Redundancy Settings Updating the Bios and Cimc Firmware System Bios and Cimc FirmwareAccessing the System Bios Motherboard Jumpers Service Jumper LocationsUsing the Bios Recovery Jumper J1E5 to Recover Corrupt Bios Clearing the Cimc Admin Password Using Jumper J45 Using the Clear Cmos Jumper J1E6 Clearing the Bios Admin Password Using Jumper J1E4 Chapter Cisco UCS C210 Server Installation and Service Guide Cisco Integrated Management Interface Cimc Server Configuration UtilityServer Monitoring and Management Tools Front Panel LEDs Status LEDsLED Name State 2shows the names and locations of the rear panel LEDs Rear Panel LEDsRear Panel LEDs LED Name State Preparing for Component Installation Shutting Down and Powering Off the Server Removing and Replacing the Server in a Rack Removing the Top Cover of the Server Removing and Replacing the Server Top CoverRemoving the Front Cover of the Server Removing and Replacing the Server Front CoverReplaceable Component Locations top view Replaceable Component LocationsInstalling or Replacing Components Installing Hard Drives and Solid State Drives Removing and Replacing Hard Drives and SSDs PSU1 Installing Power SuppliesInstalling a DVD Drive Removing and Replacing a DVD drive Installing a Fan Tray Fan tray Fan tray securing screws two on each side Memory Performance Guidelines and Population Rules Installing DIMMsFront of Server Rear of ServerMemory Population Rules Memory Mirroring and RAS Dimm Installation Procedure13 Removing and Replacing Memory Modules CPU Replacement Procedure Installing CPUs and HeatsinksChapter 14 Removing and Replacing CPUs and Heatsinks Installing a Motherboard Cmos Battery 15 Removing and Replacing a Motherboard Cmos Battery Installing a Trusted Platform Module TPMTPM Replacing a PCIe Riser Card Assembly Riser card assembly top view Replacing a PCIe Card Replacing a PCIe CardChapter 19 Removing and Replacing a PCIe Card How to Identify Which Power Supply Model is in Your Server Resolving Insufficient Memory Space to Execute Option ROMs Resolving Insufficient 16-Bit I/O Space SAS Expander Replacing a SAS Extender or SAS ExpanderSAS Extender Replacing a SAS Extender or SAS Expander Card 22 and then connect the cable to the socket on the adapter Replacing an LSI MegaRAID Battery Backup Unit22 Removing and Replacing an LSI BBU Installing a Mezzanine Card Mezzanine card retaining posts three Chapter Cisco UCS C210 Server Installation and Service Guide Description Specification Physical SpecificationsPower Specifications Environmental SpecificationsSupported Components Part Number KVM CableDescription Feet Meters Illustration Supported Power Cords and PlugsLength This section contains the AC power cord illustrations AC Power Cord IllustrationsCAB-9K10A-EU CAB-9K10A-SW CAB-N5K6A-NA CAB-9K12A-NA OL-20887-02 Supported RAID Controllers and Required Cables RAID Controller ConsiderationsRAID Levels Required Cables Max Internal Opt Controller Style DrivesRAID Controller Cabling Enabling the Mezzanine Card RAID Controller in the BiosIntegrated ICH10R How to Determine Which Controller Is in Your ServerHow To Launch Option ROM-Based Controller Utilities From your For More Information OL-20887-02 Installation for Cisco UCS Integration OL-20887-02