Cisco Systems UCS C210 manual Attaching the Cable Management Arm

Chapter

b.Push the server into the slide rails until it stops at the internal stops.

c.Push the plastic installation release clip on each mounting bracket toward the server rear (see item 5 in Figure 2-4), and then continue pushing the server into the rack until its front flanges touch the rack posts.

d.Close the front-flange latches to secure the server to the front rack posts.

Step 4 Attach the (optional) cable management arm (CMA) to the rear of the slide rails:

Note The orientation in these instructions refers to a view from the front of the server.

a.Slide the plastic clip on the right end of the CMA length-adjustment slider (item 2) into the rear of the right slide rail (item 1) until it clips onto the plastic retaining flange inside the slide rail. See Figure 2-5.

b.Expand the CMA length-adjustment slider (item 2) until its left end aligns with the rear of the left slide-rail assembly (item 3).

c.Slide the innermost CMA attachment clip (item 4) into the rear of the left slide rail (item 3) and clip it onto the CMA flange that is on the mounting bracket that is attached to the server.

d.Attach the two-hole slotted bracket (item 5) that is on the left end of the CMA length-adjustment slider to the left slide rail. Fit the two-hole slotted bracket over the two pegs inside the slide rail.

e.Attach the outermost CMA attachment clip (item 6) onto the CMA flange that is on the left slide rail.

Figure 2-5 Attaching the Cable Management Arm

6 2 1

5

4

3

				195969
1	Rear of right slide rail (plastic retaining flange	2	CMA length-adjustment slider
	is inside the rail)
3	Rear of left slide rail assembly	4	Innermost CMA attachment clip
5	Two-hole slotted bracket on end of CMA	6	Outermost CMA attachment clip
	length-adjustment slider

Step 5 Continue with the “Connecting and Powering On the Server (Standalone Mode)” section on page 2-9.

Cisco UCS C210 Server Installation and Service Guide

2-8 OL-20887-02