AXIS T90B Series
•Telemetry TEL enabled
•Telemetry input wires soldered together for automatic photocell operation
•Telemetry DIM disabled
•LED status indicators enabled
•Programming Mode
Note
Changing the settings requires a remote control (optional accessory). The illuminator must be in Programming Mode.
The illuminator automatically switches from Programming Mode to Normal Operating Mode after 4 weeks. To switch to Programming Mode, restart the illuminator.
1.Adjust the power, see Power Adjust on page 22.
2.Adjust the photocell sensitivity, see Photocell Sensitivity on page 22.
3.Set the telemetry input:
-TEL, see page 24
-DIM, see page 25
-Timer, see page 25
4.Disable the LED status indicators, see LED Status Indicators on page 26.
5.Disable remote control setup, see Disable Remote Control Setup on page 27.
6.Restore the factory default settings, see Factory Default on page 27.
Normal Operating Mode
The only function of the Remote Control available during Normal Operating Mode is LED Status Indicators, see LED Status Indicators on page 26.
21