Troubleshooting

AXIS T90B Series

Factory Default

Note

To activate this feature the button must be pressed continuously for 4 seconds. This is to avoid the possibility of activating this feature accidentally.

Once the illuminator has been programmed, the settings will be stored in a non-volatile (stored) memory. These settings are saved and reloaded if the illuminator experiences loss of power. Press the RESET button to restore the illuminator back to the factory default settings.

Disable Remote Control Setup

Note

To enable Programming Mode after remote setup has been disabled, the illuminator must be powered off for at least 10 seconds. When turned on, the illuminator automatically re-enters Programming Mode.

Disable remote setup once an individual illuminator has been programmed and is delivering the required operating performance. This will help

to avoid tampering and the possibility of receiving commands when programming other illuminators in close proximity.

Lock the illuminator settings by pressing the Disable Remote Setup button continuously for at least 4 seconds.

If remote control setup is not disabled, the illuminator will remain in Programming Mode for a pre-determined time of 4 weeks. After 4 weeks, remote control setup will be automatically disabled.

Ensure all tests are undertaken by a qualified, trained engineer.

Ensure safe working practices are followed at all times.