Axis Communications T90B30 IR-LED, T90B35 W-LED, T90B40 IR-LED, T90B25 W-LED manual Telemetry Input

Page 23

AXIS T90B Series

There are three pre-defined levels to set the lux level threshold at which the photocell turns the illuminator on or off. Select the required sensitivity level by using the buttons below.

1Photocell disabled

25 Lux On, 15 Lux Off

310 Lux On, 30 Lux Off

425 Lux On, 50 Lux Off

Telemetry Input

The telemetry input wires (orange and purple) are designed to be used with a remote switch or input from an alarm system, PIR detector, control room, video management system or camera output. The input signal can be volt-free or TTL.

23

Image 23

Contents Axis T90B Series Electromagnetic Compatibility EMC Contact Information SafetyPhotobiological Safety Disposal and RecyclingPage Other Message Levels Hazard LevelsTransportation Safety InstructionsOptional Accessories Installation StepsPackage Contents Hardware Overview Axis T90B Series Axis T90B Series Remote Control Optional AccessoriesMounting Brackets LED Indicator Indicated Behavior LED IndicatorsOperating Conditions SpecificationsConnectors and Buttons Power ConsumptionInstall the Hardware Axis T90B Series Axis T90B Series Screws Diverging lens Axis T90B Series Programming Mode Access the ProductNormal Operating Mode Photocell Sensitivity Power AdjustTelemetry Input Telemetry TEL Volt-free inputTTL input Telemetry DIM TimerLED Status Indicators Disable Remote Control Setup TroubleshootingFactory Default Basics Set up Camera, Lens and IlluminationModels Technical SpecificationsAngle PowerType Distance Approvals CasingEnvironment MountingFurther Information WeightWarranty Information Page Installation Guide