AXIS T95A00/T95A10 Dome Housing | Page 13 |
Complete the installation
1.Check that all cables and wires in the housing are properly connected.
2.Replace the top cover of the housing and tighten the screws using the supplied Allen key.
3.Connect the AXIS T95A housing to the power supply
4.Follow the instructions in the Installation Guide to install the camera on the network.
The installation is now complete.
The Axis network camera installation guide is shipped with the camera or available from the Axis website at www.axis.com.
To remove the sunshield
Remove the three screws on the side of the sunshield with a Phillips screw driver; remove the screw on the top center of the cover plate with the 4 mm Allen key.
It is recommended that this is done after the installation.