Axis Communications P5512 user manual Setting Up an Action Rule, PTZ Control

AXIS P5512-E PTZ Dome Network Camera

Events

-Recurrence – Trigger the rule periodically. SeeRecurrences, on page 33. This can for example be used to upload an image every 5 minutes.

-Use Schedule – Trigger the rule according to the selected schedule. See Schedules, on page 33.

Available actions include:

•Day/Night Vision Mode – Set day mode (IR cut filter on) or night mode (IR cut filter off).

•Overlay Text – Display an overlay text. SeeUsing Overlay Text in an Action Rule, on page 20.

•PTZ Control

-Preset Position – Go to a preset position.

-Guard Tour – Start a guard tour. SeeGuard Tour, on page 24.

•Record Video – Record video to a selected storage.

•Send Images – Send images to a recipient.

•Send Notifications – Send a notification message to a recipient.

•Send Video Clip – Send a video clip to a recipient.

Setting Up an Action Rule

An action rule defines the conditions that must be met for the product to perform an action, for example record video or send an email notification. If multiple conditions are defined, all of them must be met to trigger the action.

The following example describes how to set up an action rule to record video to a network share if there is movement in the camera’s field of view.

Set up motion detection and add a network share:

1.Go to Detectors > Motion Detection and configure a motion detection window. See page 26

2.Go to System Options > Storage and set up the network share. See page 44.

Set up the action rule:

1.Go to Events > Action Rules and click Add.

2.Select Enable rule and enter a descriptive name for the rule.

3.Select Detectors from the Trigger drop-down list.

4.Select Motion Detection from the drop-down list. Select the motion detection window to use.

5.Optionally, select a Schedule and Additional conditions. See below.

6.Under Actions, select Record Video from the Type drop-down list.

7.Select a Stream profile and configure the Duration settings as described below.

8.Select Network Share from the Storage drop-down list.

To add additional criteria, select the Additional conditions option and add additional triggers. To prevent an action from being triggered repeatedly, a Wait at least time can be set. Enter the time in hours, minutes and seconds, during which the trigger should be ignored before the action rule can be activated again.

The recording Duration of some actions can be set to include time immediately before and after the event. Select Pre-trigger time and/or Post-trigger time and enter the number of seconds. When While the rule is active is enabled and the action is triggered again during the post-trigger time, the recording time will be extended with another post-trigger time period.

31