Axis Communications Focus Assistant Axis P1343/P1344/P1346/P1347, Example image Axis P1343

6.On the Focus page, click Fine-tune focus automatically and wait until the automatic fine- tuning is completed.

7.Click Enable iris. If the button is inactive, the iris has already been enabled.

8.If needed, make further adjustments under the Advanced tab. See the online help or User’s Manual for more information.

Notes:

•Set focus as precisely as possible with the focus puller or Focus Assistant before starting the automatic fine-tuning. Using the focus puller normally gives the best result.

•The iris should always be opened to its maximum while focusing; this gives the smallest depth of field and thus the best conditions for correct focusing.

Focus puller

Control button

Zoom puller

Status LED

Example image: AXIS P1343

Focus Assistant (AXIS P1343/P1344/P1346/P1347)

To focus AXIS P1343/P1344/P1346/P1347 using the Focus Assistant, follow the instructions in steps 1 - 3 on page 12 before you start with the steps below.

1.Mount or place the camera so that it cannot be moved.

2.Loosen the zoom puller by turning it anti-clockwise. Move the puller to set the zoom level. Retighten the zoom puller.

3.Set the camera to its extreme distant-focus position by loosening the focus puller and turning the lens fully clockwise.

4.Press and quickly release the Control button. When the Status LED flashes green, the Focus Assistant is enabled.

If the Status LED flashes either red or amber before you are able to adjust the lens, skip to step 7 to exit the Focus Assistant and repeat steps 3 - 7. See the notes below.

ENGLISH