Axis Communications P1344-E user manual Connectors

Page 7

AXIS P1344-E Network Camera

Hardware overview

15.Bracket screws (4x)

16.Bracket adapter

17.Network cable (route through wall bracket)

18.Wall bracket

19.Bracket adjustment screw

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).

Caution

To protect the product against power surges, a shielded network cable (STP) must be used between the product and the network switch. Ensure that the network switch is properly grounded.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker with a built-in ampliﬁer. A stereo connector must be used for the audio out.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For instructions on how to insert and remove an SD card, please refer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup > System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

•Enabling the Focus Assistant. Press and very quickly release the Control button.

•Connecting to an AXIS Video Hosting System service. See page 43. To connect, press and hold the button for about 1 second until the Status LED ﬂashes green.

•Connecting to AXIS Internet Dynamic DNS Service. See page 43. To connect, press and hold the button for about 3 seconds.

•Resetting the product to factory default settings. See page 49.

Power connector - 2-pin terminal block for power input.

I/O connector

DC power input

Note

For technical speciﬁcations, see page 56.

7

Image 7

Contents Axis P1344-E Network Camera Equipment Modiﬁcations About this documentLiability Intellectual Property RightsAxis P1344-E Network Camera Table of ContentsTechnical Speciﬁcations Hardware overview Hardware overviewAxis P1344-E Network Camera Connectors GND Function Pin SpeciﬁcationsReplacing the lens LED indicatorsStatus LED when using Focus Assistant MaintenanceAttach and screw on the new lens Accessing the product Accessing the productAccess from a browser Click Create self-signed certiﬁcate Access from the InternetSet the root password Network TCP/IP AdvancedControls on the Live View Live ViewPTZ Controls Axis Media Control viewer toolbarAMC Audio controls Axis P1344-E Network Camera Axis Media Control AMC How to stream H.264Media streams Media streamsAlternative methods of accessing the video stream Accessing audio streams Setting up the product Setting up the productBasic Setup Pixel Counter Video and AudioVideo and Audio Video StreamImage Stream Proﬁles264 White balance Camera SettingsExposure Settings Image AppearanceOverlay View AreaAudio Channels Audio SettingsPrivacy Mask FocusG711 G726 Audio InputAudio Output Audio ClipsLive View Conﬁg Default viewer for browsersLive View Conﬁg Browser Viewer Description Viewer SettingsUser Deﬁned Links Output ButtonsGuard Tour Preset PositionsPTZ Pan Tilt Zoom PTZ Pan Tilt ZoomControls AdvancedMotion Detection DetectorsDetectors Camera TamperingMotion detection parameters Set up motion detectionGo to Detectors Audio Detection Default valuesAudio detection Recommended valuesApplications ApplicationsConvert Event Types to Action Rules Setting Up an Action RuleEvents EventsSchedules RecipientsRecurrences Axis P1344-E Network Camera Continuous recording RecordingsRecordings Recording ListAxis P1344-E Network Camera Users System OptionsSystem Options SecurityIeee Date & TimeAudio Support IPv6 Address Conﬁguration Basic TCP/IP SettingsNetwork IPv4 Address ConﬁgurationAdvanced TCP/IP Settings NAT traversal port mapping for IPv4 Link-Local IPv4 AddressSmtp email QoS Quality of ServiceBonjour StorageUPnPTM RTP/H.264Ports MaintenancePorts & Devices Network ShareLogs & Reports SupportSupport Overview System OverviewPlain Conﬁg Reset to factory default settingsScripting File UploadAxis P1344-E Network Camera Checking the ﬁrmware TroubleshootingTroubleshooting Emergency recovery procedureProblems setting the IP address Symptoms, possible causes and remedial actionsProduct cannot be accessed from a browser Problems with the H.264 format Product is accessible locally but not externallyStatus and Network indicator LEDs are ﬂashing red rapidly No images displayed on web Video and image problems, generalSetup Video & Audio Camera Settings Problems uploading ﬁlesPoor audio quality SettingsStorage and disk management problems No audioTechnical Speciﬁcations Technical SpeciﬁcationsNetwork Security Maintenance Installation aidsMemory Power ConnectorsPerformance considerations M2.3