Bosch Appliances VG4-300, VG4-200, VG4-500I user manual 11.2 VG4 IP AutoDome Video and Control

120 en Troubleshooting GuideVG4 Modular Camera System

Inside of	– Check the status of the Heater Module (ON-66-ENTER).
EnviroDome bubble	If status reports Heater No Power, then:
is foggy	– Turn off the power to the AutDome.
	– Check the FX103 fuse in the Power Supply Box for power (24 V) to the heater module.
	If O.K., then:
	– Check all wiring and connector pins to the heater module.
Low Voltage flashing	– If using a non-Bosch power supply, confirm that it meets the Bosch AutoDome power
on monitor display	ratings. See the AutoDome Datasheet for specifications.
	If O.K., then:
	– Check the mains input line voltage.
	If O.K., then:
	– Check that the maximum wire length from the power supply has not been exceeded.
	See the AutoDome Modular Camera System Installation Manual.
	If O.K., then:
	– Measure the AC voltage input to the camera while power is applied to the camera. The
	voltage must be ≥ 21 VAC to stop the message.

11.2	VG4 IP AutoDome Video and Control
Problem		Solution
No Network		– Check all network connections
Connection		–	Ensure that the maximum distance between any two Ethernet connections is 100
			m (328 ft) or less.
			Refer to the AutoDome Modular Camera System Installation Manual for more infor-
			mation.
		If O.K., then:
		– If you are behind a firewall, ensure that the Video Transmission mode is set to UDP.
		a.	Access the Settings Web page for the IP-enabled device.
		b.	Expand the Service Settings link, then click Network.
		c.	Select UDP from the Video Transmission drop-down list. Then click Set.

F.01U.133.268 6.0 2010.03 User’s Manual Bosch Security Systems, Inc.