VIP X1600 XFInstallation en 17
4.5 | Power On/Power Off |
4.5.1 | Power Supply |
| The VIP X1600 XF does not have a power switch. Power is provided once one or two separate |
| power supply units have been installed. Connect the VIP X1600 XF to a power supply unit and |
| plug this into the mains. The unit is now ready for use. The VIP X1600 XF does not come |
| supplied with a power supply unit. |
CAUTION!
Use only power supply units approved by Bosch Security Systems.
!Where necessary, use suitable equipment to ensure that the power supply is free from interference such as voltage surges, spikes or voltage drops.
Do not connect the VIP X1600 XF to the power supply until all other connections have been made.
The unit is ready for operation after the VIP X1600 XF has been connected to the power supply and the mounted modules have been initialized.
The operational state of each module is indicated by an LED on the front panel of the VIP X1600 XF.
If a network connection has been set up correctly, the corresponding LEDs on the RJ45 sockets ETH1, ETH2 or ETH3 light up. Flashing LEDs signal that data packages are being transmitted over the network. In the case of a redundant network connection, or a direct connection to an iSCSI system, these signals can also be seen on the LEDs of all RJ45 sockets in use.
i | NOTICE! | |
For more information about the LEDs, see Section 6.2 LEDs, page 21. | ||
|
Bosch Security Systems | Installation and Operating Manual | F.01U.082.088 V3.5 2008.05 |