VIP X1600 XFSafety Information en 7
2 | Safety Information |
2.1 | Electric Shock Hazard |
| – Never attempt to connect the unit to any power network other than the type for which it |
| is intended. |
| – Use only power supply units approved by Bosch Security Systems. |
| – Never open the housing of the power supply unit. |
| – Always install a module in the appropriate VIP X1600 XF base housing only. |
| – If a fault occurs, disconnect the VIP X1600 XF from the power supply and from all other |
| units. |
| – Install the power supply and the unit only in a dry, |
| – If safe operation of the unit cannot be ensured, remove it from service and secure it to |
| prevent unauthorized operation. In such cases, have the unit checked by Bosch Security |
| Systems. |
| Safe operation is no longer possible in the following cases: |
| – if there is visible damage to the unit or power cables, |
| – if the unit no longer operates correctly, |
| – if the unit has been exposed to rain or moisture, |
| – if foreign bodies have penetrated the unit, |
| – after long storage under adverse conditions, or |
| – after exposure to extreme stress in transit. |
2.2 | Installation and Operation |
| – The relevant electrical engineering regulations and guidelines must be complied with at |
| all times during installation. |
| – Relevant knowledge of network technology is required to install the unit. |
| – Before installing or operating the VIP X1600 XF, make sure you have read and understood |
| the documentation for the modules in use and for any other equipment connected to it, |
| such as cameras or monitors. The documentation contains important safety instructions |
| and information about permitted uses. |
| – Perform only the installation and operation steps described in this manual. Any other |
| actions may lead to personal injury, damage to property or damage to the equipment. |
2.3 | Maintenance and Repair |
| – Never open the housing of a VIP X1600 XF base. The unit does not contain any user- |
| serviceable parts. Remove only the supplied cover when installing a module. |
| – Do not change any components in a VIP X1600 XF base or a module. The units do not |
contain any
– Never open the housing of the power supply unit. The power supply unit does not contain any
– Ensure that all maintenance or repair work is carried out only by qualified personnel (electrical engineers or network technology specialists).
Bosch Security Systems | Installation and Operating Manual | F.01U.082.088 V3.5 2008.05 |