Bosch Appliances 7000 manual Important Notices, Coax grounding

8 en Safety EN AutoDome 7000 Series (IP and HD)

exposure to moisture, water, and/or inclement weather (rain, snow, etc.); liquid has been spilled in or on the equipment;

an object has fallen into the unit;

unit has been dropped or the unit cabinet is damaged; unit exhibits a distinct change in performance;

unit does not operate normally when the user correctly follows the operating instructions.

13.Replacement parts - Be sure the service technician uses replacement parts specified by the manufacturer, or that have the same characteristics as the original parts. Unauthorized substitutions may cause fire, electrical shock, or other hazards.

14.Safety check - Safety checks should be performed upon completion of service or repairs to the unit to ensure proper operating condition.

15.Installation - Install in accordance with the manufacturer's instructions and in accordance with applicable local codes.

16.Attachments, changes or modifications - Only use attachments/accessories specified by the manufacturer. Any change or modification of the equipment, not expressly approved by Bosch, could void the warranty or, in the case of an authorization agreement, authority to operate the equipment.

1.5 Important Notices

Accessories - Do not place this unit on an unstable stand, tripod, bracket, or mount. The unit may fall, causing serious injury and/or serious damage to the unit. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer. When a cart is used, use caution and care when moving the cart/apparatus combination to avoid injury from tip-over. Quick stops, excessive force, or uneven surfaces may cause the cart/unit combination to overturn. Mount the unit per the manufacturer's instructions.

All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at least 3 mm in each pole, into the electrical installation of the building.If it is needed to open the housing for servicing and/or other activities, use this all-pole switch as the main disconnect device for switching off the voltage to the unit.

Camera grounding - For mounting the camera in potentially damp environments, ensure to ground the system using the ground connection of the power supply connector (see section: Connecting external power supply).

Camera lens - An assembled camera lens in the outdoor housing must comply and be tested in accordance with UL/IEC60950. Any output or signal lines from the camera must be SELV or Limited Power Source. For safety reasons the environmental specification of the camera lens assembly must be within the environmental specification of -10 °C (14 °F) to 50 °C (122 °F). Camera signal - Protect the cable with a primary protector if the camera signal is beyond 140 feet, in accordance with NEC800 (CEC Section 60).

Coax grounding:

–Ground the cable system if connecting an outside cable system to the unit.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems