Panasonic WV-BP332, WV-BP334 manual Mounting the Lens

Page 14

Mounting the Lens

Caution:

Before you mount the lens, loosen the two screws on the ring, and rotate this ring clockwise until it stops. If the ring is not at the end, the inner lens or CCD image sensor may be damaged.

1.Mount the lens by turning it clockwise on the lens mount of the camera.

2.Connect the lens cable to the auto iris lens con- nector on the side of the camera.

Screws

1

2

Flange-back

Adjusting Ring

Caution for Mounting the Lens

The lens mount should be a C-mount or CS-mount (1”- 32UN) and the lens weight should be less than 450g (0.99 lbs). If the lens is heavier, both the lens and cam- era should be secured by using the supporter.

The protrusion at the rear of the lens should be as shown below:

C-mount: Less than 11.5 mm (7/16”)

CS-mount: Less than 7.2 mm (1/4”)

-12-

Image 14
Contents WV-BP330/WV-BP332/WV-BP334 EnglishFor U.S.A Contents Features PrefaceDo not attempt to disassemble the camera PrecautionsClean the CCD faceplate with care Handle the camera with careMajor Operating Controls and Their Functions WV-BP334Power Cord only WV-BP330 Auto Iris lens ConnectorFlange-back Adjusting Ring Lens option Camera Mounting Screw Hole4Vertical Phase Control Phase only WV-BP330 and WV-BP334 1Back Light Compensation Mode Selector BLC2Lens Drive Signal Selector VIDEO, DC 6Video Output Connector Video OUT7Gen-lock Input Connector GEN-LOCK Connections WV-BP332 12V DCVideo Cable Type RG-59/U RG-6/U RG-11/U RG-15/U Coaxial cable Installation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Installation of Camera Mounting from the bottomPrevention of Blooming and Smear Specifications Standard Accessories Video Imaging Systems Company